Give any two technical issues/ problems in extracting oil
Q: 5.5 The mean daily flows at a gauging station for a period of 7 days are 7,27,58,41.31.20 and 13m'is…
A:
Q: Depending upon the ________ parameters single stage / multistage separation of oil & gas can be…
A: Given:- Depending upon the ________ parameters single-stage / multistage separation of oil & gas…
Q: 2/ The estimated mass from an instantaneous spill of benzene was 214 kg over 2m of the one dimension…
A:
Q: A roadway section is 3000 ft long (15 stations), the end area values (ft?) are Aoc= 3, Aor=15,…
A: Option b is
Q: 2. A hydraulic car lift uses a small piston with a cross-sectional area of 2.50 cm and a large…
A:
Q: Characteristics and applications of filtration. Main parameters to consider in the filtering…
A: Introduction : Filtration , the process in which solid particles in a liquid or gaseous fluid are…
Q: Regarding clarification, settling method can be accelerated by: a)increasing gravitational…
A: Required : How can the settling method be accelerated.
Q: PROBLEM 1: Reynold's number is used to determine the type of flow pattern througha pipe. It is…
A:
Q: Two streams merge to form a river. One stream has a width of 8.5 m, depth of 3.4 m, and current…
A: Stream 1 Width, w1 = 8.5 m Depth, d1 = 3.4 m Current speed, v1 = 2.2 m/s Stream 2 w2 = 6.9 m d2 =…
Q: A typical deep foundation project may include several hundred piles, but only one or two static load…
A: A typical deep foundation project may include several hundred piles whereas, only one or two static…
Q: ched to a piston of area 3.83 cm2, what is the mass of the customer that the customer can raise?…
A: GivenForce applied by barber, F1=100 NArea of Hydraulic piston, A1=1.39 cm2=1.39×10-4 m2Chair…
Q: QUESTION 2 a) With reference to a control volume device, define mass flow rate and volume flow rate.…
A: Solution-(a) Mass flow rate:-Mass flow rate is defined as the rate at which a fixed quantity of mass…
Q: Draw a cross-section and explain how quicksand forms.
A: A constant flow of water causes the sand to get wet. Since water cannot escape it liquifies the…
Q: Explain the term balance point as applies to the Wheatstone Bridge.
A: Answer A Wheatstone bridge is a special arrangement of 4 resistors it can be used to find an unknown…
Q: 1/ From the below Figure, calculate the following: a. Calculate the mass flow rate of product P. b.…
A:
Q: fined the average infiltration capacity at 60 * min A ring infiltrometer test were made on sandy…
A:
Q: i need a example of a water cycle in science
A: Required : Example of the water cycle in science.
Q: A piece of household aluminum foil is 0.016 mm thick. Use a piece of foil that measures 10 cm by 15…
A: Introduction: The buoyant force is the net upward force on any object in any fluid. The buoyant…
Q: An open cylindrical tank with a diameter of 2 m. has Water (s.g. = 1.00, h 2m), Oil (s.g. 0.82,…
A:
Q: Identify the following direction using the appropriate Miller Indices or Miller-Bravais Index…
A: Given, Hexagonal crystal
Q: A concrete mix design anticipates using 270 Ibs of water / cubic yard. All aggregate is determined…
A: Given Data: The amount of water in concrete mix design is, W=270 lbs of water/cubic yard The…
Q: 5. A wooden raft has a density of 600 kg/m3. Its surface area is 5.7 m2 and its volume is 0.60 m3.…
A:
Q: a) the approximate diameter of the sedimenter by the method of Talmadge and Fitch; b) the height of…
A:
Q: 11) Seawater contains approximately 3.5% salt by weight, what is the of the seawater containing 3 kg…
A:
Q: A stream moving with a speed of 0.5 m/s reaches a point where the cross-sectional area of the stream…
A:
Q: If 5.3 cm contains a blood which has a density of 1060 Kg/m, Find its mass. Answer:
A:
Q: If 50.00 mL of blood has a mass of 52.00 grams, what is its density? (Be sure to include units in…
A: volume of blood (V) = 50 mL mass of blood (m) = 52 grams
Q: Explain different type of stress.
A: There are two types of stress.Normal Stress : Caused due to normal forces (forces perpendicular to…
Q: A hydraulic lift has an out
A: GIVEN THAT A hydraulic lift has an output force of 10,000N from a piston with a cross-sectional area…
Q: 6. If a hydraulic pump had an input force from a piston of 10 N over an area of 10 square meters,…
A:
Q: Detailed work required. Do not use Artificial intelligence
A:
Q: 2) Initially, a tank contains 3 m' of salt-free water. A stream enters into the tank at a constant…
A:
Q: A cylinder contains oil, water and petrol as shOwn below. Petrol Oil Water Which of the following…
A: If the fluid has lower density than another fluid, it will contain above the fluid with the higher…
Q: what are the characteristics of a solid ? it had ____ shape and a definite ____
A: Required : Properties of solids.
Q: Give four specifications of oil and gas perforating gun from any oil and gas company or pipe…
A: Four specifications of an oil and gas operating gun: 1) Gun can create fractures of nearly 50 ft in…
Q: Which of the following statements are true with respect to streamlined flow systems? Note: Select…
A: This eliminate unnecessary work related task to improve the efficiency of the process.
Q: You have 1.5 (106) gallons of wastewater flow where the oxygen demand is 267 mg/L, how much air…
A: Given: The amount of wastewater is 1.5106 oxygen demand is 267 mg/L Density of air is 1.225 kg/m3
Q: An artist creates a solid sculpture made from 7.60 kg of aluminum. She wishes to create an identical…
A:
Q: 10 Which of the following best describes a drain waste vent? (1) A liquid seal in the pipes carrying…
A: A drain waste vent is a system which allows air to enter within the plumbing system so that is…
Q: Is a water dam a challenging forth or bringing forth? Explain.
A: A water dam a challenging forth .
Q: 2) 35 g of iron pellets are added to a graduated cylinder containing 50 ml of water. The water level…
A: Mass of iron pellet m=35 g=0.035 kg Volume of the liquid VL=50 mL Volume of the water +pellet…
Give any two technical issues/ problems in extracting oil
Step by step
Solved in 2 steps
