G6//The light rigid bar ABCD shown in Figure is pinned at B and connected to two vertical rods. Assuming that the bar was initially horizontal and the rods stress-free, determine the stress in each rod after the load after the load P 20 KN is applied. Steel L=2m A=250mm? 4m E=200Mpa A D Aluminum L=2m A=500mm 2m 2m E=72Mpa P=20KN

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A:

Q: 5 The supports of Beam AD are aluminum rod and st eel rod only. Determine the stress in the aluminum…

A:

Q: Q1) Three bars AB, CD and ED are used to support ACE beam. The three bares have modulus of…

A: Draw the free body diagram. Equilibrium of vertical forces,…

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A:

Q: A steel rod 26 mm diameter has a brass sleeve 40 mm external diameter and 26 mm internal diameter…

A: Axial deformation in a bar takes place due to axial force. The axial force depends upon the…

Q: Three round bars welded together axially loaded as shown. Find the normal are stress in each bar if…

A: Stress is defined as the force acting per unit area of a bar. The stress in a bar is directly…

Q: A rod is composed of an aluminum section rigidly attached between steel and bronze sections, as…

A: σ=PA     ----( 1 ) here σ is stress , A is cross sectional area and P is force applied Calculate σst…

Q: Determine the force in the member CD of the truss and state whether it is in tension or compression…

A: At Joint C,

Q: In the stepped shaft given in the figure, what will then be the P force provided that the stress in…

A: Given data in question Load 120 kNDiameter 50 and 75 mmLength750 & 1000 mmTo find out Load P

Q: SITUATION. As shown in the figure below, a rigid bar with negligible mass is pinned at O and…

A:

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.