ft3 min A two-stage compressor receives air at 100 at 10psia and the discharge pressure is 200 psia. If the temperature of the air received is 50F, find the intercooler pressure, total compressor work and total heat rejected at the intercoolers. 44.72psia; 16.31 hp; 345.80 min Btu

ft3 min A two-stage compressor receives air at 100 at 10psia and the discharge pressure is 200 psia. If the temperature of the air received is 50F, find the intercooler pressure, total compressor work and total heat rejected at the intercoolers. 44.72psia; 16.31 hp; 345.80 min Btu

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Csider a turbojet powered airplane flying at a standard altitude of 9144 m at a veloc- 84.67 kmph.…

A: Turbojet thrust formula T = m. (Ve-Va) + Ae(pe-pa) Ve: exit velocity Va: inlet velocity pe: exit…

Q: Steam enters the turbine at 10 bar. Output pressure P = 1 bar, knowing turbine efficiency is 80%.…

A: GIvenP1=10 barP2=1barηT=80%part awhen T1=250oCPart b when T1=325oC

Q: an air flow is brought from 20 degree celsius, 100 kPa to 1000 kPa, 330 degree celsius by an…

A: Given, Inlet, Outlet, The compressor power,

Q: Apply the first law of thermodynamics to power requiring compressor. Assume that the process is…

Q: A pressure relief valve is installed in a rigid 25-L steam cooker to release vapor and maintain…

A: To determine the smallest entropy change of the thermal energy reservoir.

Q: ammonia vapor is compressed in a close system from 15 psia,3 cu ft to 150psia,0.4cu ft. according to…

Q: QI. Six cylinders, 3.2 liter, supercharged engine operating at 3000 rpm have an overall volumetric…

Q: A four stage single acting air compressor running in an atmospheric at 87 KPa and 15 degrees Celsius…

Q: A stationary diesel engine with a thermal efficiency of 40% produces 200 horsepower. The exhaust…

A: NOTE:- There is a slight error in the question. Instead of velocity, temperature should be written…

Q: There are compressed 1122 lb/hr of oxygen by a 13.92" x 14", double acting, motor driven compressor…

A: Given dataP1=14.7 Psi=101.35kPaT1=106F=314.26KP2=45 Psi=310.264 kPaN=100 rpmm˙=1122 lb/hr=0.1539694…

Q: Air with a pressure of 0.1 MPa and a temperature of 25oC with a flow rate of 5.29 kg/minute enters a…

Q: A steam power plant operates with a boiler at 5000 kPa and 500 °C. The turbine exhaust is saturated…

A: To determine Wt, Wp, Qh and Qc for the given cycle

Q: A pump operates between 100kPa and 10MPA. If the mass flow rate of the pump is 20.8 kg/s, and the…

Q: 4. A two-stage compressor receives 0.35kg/s of air at 100kPa and 269K and delivers it at 5MPa. Find…

A: givenm=0.35kg/sP1=100kPaT1=269KP2=5Mpa

Q: A 5 m3 rigid tank has propane at 500 kPa, 700 K and connected by a valve to another tank of 0.7 m3…

Q: A fan which ventilates a small mine run at 500 rev/min. The airflow is measured at 150m3/s when the…

A: Fan speed, = 500 Air flow, = 150 Pressure drop, Efficiency of fan, It is asked to find the speed,…

Q: Nitrogen gas is being compressed from 105 kPa and 295 K to 460 kPa and 553 K, if 17 kJ/kg of heat…

Q: Air with a flow rate of 72 m3/s, a pressure of 101 kPa, and a temperature of 27oC, enters a…

A: detailed answer given in attachment kindly refer it.

Q: b) A steam turbine that uses refrigerant 134-a as the working fluid is passed through a diffuser.…

Q: A room being air conditioned is held at 25°C db & 50% RH. A flow rate of 5m³/s of supply air at 15°C…

A: Given data P=100 kPaV1=5 m3/sT1=15°C Here, P is the pressure and V1 is the volume of the air flow.…

Q: Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam…

A: Calculate the total pump work of the cycle?

Q: Q/Caleulate the power in kilowatts of the gas turbine power plant has a greatest temperature of 700…

Q: A turbocharged, 4 cylinders and 2 liters engine operates with stoichiometric gasoline, 2000 rpm, and…

A: please refer handwritten solution

Q: from these states to a pressure of 6.5 bar. Calculate the power required for drivir the compressor…

A: Given data; P1=1 bar=100 KN/m2t1=170CT1=17+273=300 KV1=15 m3/minP2=6.5 bar=650 KN/m2 as per…

Q: vapor compression system is designed to have a capacity of 100 tons. its actual cop is 5.86 and 35…

A: Given:Cooling capacity, Q=100 tonsCOP=5.86%age lost=35%

Q: p Solution with brief explanation. Answer is around 365kPa,But I need Solution. 1) A 3-stages air…

A: Given:Number of stages, n=3Initial pressure, P1=700 kPaFinal pressure, P4=700 kPa

Q: A 2-stage compressor is used to compress from 1.0 bar to 12 bar. The compression is as per the law…

A: Given: P1=1.0 barP4=12 barT1=300 KV1=4m3/min

Q: A four-stage single-acting air compressor running in an atmospheric at 87 kPa and 15°C has a F.A.D…

Q: A two-stage reciprocating air compressor takes air at 1 bar and 273k. This air is then delivered at…

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: A turbo-Compressor takes 9691b/ min mass of refrigerant gas for Air-conditioning unit at atmospheric…

Q: team is throttled to 0.15 MPa, 140 0C. What is the quality of throttled steam if its pressure is…

A: Given:Intial pressure, P1=0.15 MPaInitial temperature, T1=140°CFinal pressure, P2=0.85 MPa

Q: 4. Air at 150 Psi and 900F is expanded in a gas turbine to 10 psi and 279F. The air enters the…

Q: 1.Atmospheric air enters a single stage screw compressor at 1 bar and 250C at low velocity. The…

A: To Find : The heat that needs to be taken away by the after cooler. Given : The pressure inlet of…

Q: A turbine operating in a continuous flow works adiabatically. The water vapor enters the turbine at…

A: Given, T1 = 650 C P2 = 20 kPa x2 = 0.85 P = 10 MW

Q: A four-stage compressor works between limits of 1 bar and 120 bar. The index of compression in each…

Q: Q1 Figure Q1, A turbo-compressor supplies power to the air-condition unit (hea pump) with 798,22kw.…

Q: Q2. An idea Otto cycle has a compression ratio of 11, takes in air at 100 kPa and 25 °C. The…

Q: A large tank filled with water and open to the atmosphere is used to extinguish a fire in an…

Q: : A Steam enters turbine at nate of 20X10 K/ hr and at F00 Kpa & 450 C. At the turbine exhaust, the…

A: This question is based on the steady flow energy equation applied to the turbines. Assumption taken…

Q: Refer to the steam power plant below and determine the following: ii. i. Specific enthalpy at the…

Q: Steam engine with incomplete expansion receives saturated steam at 1.04 Mpa, expands it to 0.105 Mpa…

A: Since, you have posted multiple subparts and each subparts, there is more than one question. So, as…

Q: A single-stage double-acting air compressor compresses the air from 1 bar to 7.5 bar. The compressor…

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

ft3
min
5. A two-stage compressor receives air at 100 at 10psia and the
discharge pressure is 200 psia. If the temperature of the air received is
50F, find the intercooler pressure, total compressor work and total heat
rejected at the intercoolers. 44.72psia; 16.31 hp; 345.80 Bu
min

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q17
Solve both please
Ggg
Q2Air enters an insulated turbine at 50°C, and exits the turbine at - 30°C, 100 kPa.The isentropic turbine efficiency is 70% and T1=50C V=20L/s the inlet volumetric flow rate is 20 L/s. What is the turbine Air turbine inlet pressure and the turbine power output? T2=-30C.P2=100kpa
Q2 Figure Q2, A turbo-compressor supplies power to the air-condition unit (Refrigerant) with 900.0 kw. Calculate the volume per minute of the gas operating through the unit where the density is 1 Ib/ft. Given Data: TH Atmospheric temperature = 520°R Compressor gas temperature = 607°R CP 0.539, J=778J/S, Conversion factor =33000.0 One-hours power = 746 watts. QH R 900.0kw Figure (Q2), Refrigerant unit TL
For the air compressor shown in Figure below, the air enters from a large area and exit from small one, explain why?
Problem 4. Consider an adiabatic steam turbine operating at steady-state with a mass flow rate of 12 kg/s. At the inlet, the steam pressure is 10 MPa, the temperature is 450 °C, and the velocity is 80 m/s. At the exit, the pressure is 10 kPa, a quality of 0.92, and a velocity of 50 m/s. Find the change in kinetic energy Wout = ? Steam turbine (kJ/kg), the work out (power generated in MW), and the turbine inlet area (m²).
4. A single-stage cylinder air compressor is rated at 6.5 cubic meter per minute of air .Suction conditions are 1 atm and 27 deg C and discharge pressure of 1034 KPa. The compression process follows PV1.35 = C. What is the engine Kw power needed to drive the unit if the combined engine-compressor efficiency is 84%?
10. For the flow in reciprocating compressor, the change in the kinetic energy is maximum
QUESTION 27 A four-stage single-acting air compressor running in an atmospheric at 87 kPa and 15°C has a F.A.D of 2.83 m³/min. The section pressure and temperature are 80 kPa and 32 °C respectively, the delivery pressure is to be 7 MPa. The temperature at the start of compression in each stage is 32 °C, take n=1.3 for all stages. With reference to formula file the applicable formual number to find the mass flow rate and power input is and , respectively. The mass flow rate to 3 decimal places in kg/min and power input in kW to 1 decimal place are: , and , respectively. No need to add units
4
b- An evacuated tank ,shown if fig of 1 ft3 is coupled to air supply line through valve .When the valve is opened, the air flow from supply line at 70°F,120 psi until the pressure reaches 90psi . calculate the final temperature and mass inside tank ,assuming the process is adiabatic. R= 53.34 Ibf-ft/lbm °R use the table below in case. Alr supply line Tank Idcat-Gas Propertiles of Air (English Units)0, Standard Entropy at 1 atm = 161.325 kPa = 14.696 1bf/in.² (R) (Btulbm) (Btu/lbm) (Btu/lbm R) (R) (Btu/lbm) (Btu/lbm) (Btu/Ibm R) 400 68.212 95.634 1.56788 1950 357.243 490.928 1.96404 440 75.047 105.212 1.59071 2000 367.642 504.755 1.97104 480 81.887 114.794 1.61155 2050 378.096 S18.636 1.97790 520 88.733 124.383 1.63074 2100 388.602 532.570 1.98461 536.67 91.589 128.381 1.63831 2150 399.158 546.554 1.99119 540 92.160 129.180 1.63979 2200 409.764 560.588 1.99765 560 95.589 133.980 1.61852 2300 431.114 588.793 2.01018 600 102.457 143.590 1.66510 2400 452.640 617.175 2.02226 1000 172.564…