From one corner of a thin homogeneous square metal sheet with sides of L = 20 cm is cut an L/2 square sheet as shown in the figure. Approximately how far away is the centre of mass of the resulting shape from the centre P of the original square? P ○ 24 mm ○ 42 mm ○ 32 mm ○ 16 mm

From one corner of a thin homogeneous square metal sheet with sides of L = 20 cm is cut an L/2 square sheet as shown in the figure. Approximately how far away is the centre of mass of the resulting shape from the centre P of the original square? P ○ 24 mm ○ 42 mm ○ 32 mm ○ 16 mm

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter9: Linear Momentum And Collisions

Section: Chapter Questions

Problem 24P: A uniform piece of sheet metal is shaped as shown in Figure P9.24. Compute the x and y coordinates...

See similar textbooks

Similar questions

Two metersticks are connected at their ends as shown in Figure P10.18. The center of mass of each individual meterstick is at its midpoint, and the mass of each meterstick is m. a. Where is the center of mass of the two-stick system as depicted in the figure, with the origin located at the intersection of the sticks? b. Can the two-stick system be balanced on the end of your finger so that it remains lying flat in front of you in the orientation shown? Why or why not? FIGURE P10.18 (a) The center of mass of the stick on the x axis would be at (0.5 m, 0), and the center of mass of the stick on the stick on the y axis be at (0, 0.5 m), assuming the sticks are uniform. We can then use Equation 10.3 to find the x and y coordinates of the center of mass. xCM=1Mj=1nmjxj=12m[m(0.50m)]=0.25myCM=1Mj=1nmjyj=12m[m(0.50m)]=0.25m The location of the center of mass is (0.25m,0.25m) (b) No. The location of the center of mass is not located on the object, so your finger would not be in contact with the object. In a different orientation, balancing by applying a force at the center of mass might be possible, but not in the orientation shown.
A baseball bat of uniform density is cut at the location of its center of mass as shown in Figure 9.18. Which piece has the smaller mass? (a) the piece on the right (b) the piece on the left (c) both pieces have the same mass (d) impossible to determine Figure 9.18 (Quick Quiz 9.7) A baseball bat cut at the location of its center of mass.
Check Your Understanding Suppose you have a macroscopic salt crystal (that is, a crystal that is large enough to be visible with your unaided eye). It is made up of a huge number of unit cells. Is the center of mass of this crystal necessarily at the geometric center of the crystal?
A crate of mass M is initially at rest on a frictionless, level table. A small block of mass m (m M) moves toward the crate as shown in Figure P10.31. Later, the block and crate are stuck together and are moving with some final speed. The momentum of the blockcrate system is the same both before and after the collision. Is the magnitude of the change in momentum of the crate greater than, less than, or equal to the magnitude of the change in the momentum of the block? Explain. FIGURE P10.31
A car crashes into a large tree that does not move. The car goes from 30 m/s to 0 in 1.3 m. (a) What impulse is applied to the driver by the seatbelt, assuming he follows the same motion as the car? (b) What is the average force applied to the driver by the seatbelt?
The vector position of a 3.50-g particle moving in the xy plane varies in time according to r1=(3i+3j)t+2jt2, where t is in seconds and r is in centimeters. At the same time, the vector position of a 5.50 g particle varies as r2=3i2it26jt. At t = 2.50 s, determine (a) the vector position of the center of mass of the system, (b) the linear momentum of the system, (c) the velocity of the center of mass, (d) the acceleration of the center of mass, and (e) the net force exerted on the two-particle system.
Problems 44 and 45 are paired. C A model rocket is shot straight up. As it reaches the highest point in its trajectory, it explodes in midair into three pieces with velocities indicated by the arrows in Figure P10.44, as viewed from directly above the explosion. Rank the mass of each piece in order from smallest to largest and justify your answer. FIGURE P10.44 Problems 44 and 45.
A water molecule consists of an oxygen atom with two hydrogen atoms bound to it (Fig. P8.36). The angle between the two bonds is 106. If the bonds are 0.100 nm long, where is the center of mass of the molecule? Figure P8.36
A bullet of mass m is fired into a ballistic pendulum and embeds itself in the wooden bob of mass M (Fig. P11.33). After the collision, the pendulum reaches a maximum height h above its original position. a. Show that the kinetic energy of the system decreases by the factor m/(m + M) immediately after the collision. b. What is the change in momentum of the bullet-bob system due to the collision? FIGURE P11.33
A ball of mass 50.0 g is dropped from a height of 10.0 m. It rebounds after losing 75% of its kinetic energy during the collision process. If the collision with the ground took 0.010 s, find the magnitude of the impulse experienced by the ball.
Two skateboarders, with masses m1 = 75.0 kg and m2 = 65.0 kg, simultaneously leave the opposite sides of a frictionless half-pipe at height h = 4.00 m as shown in Figure P11.49. Assume the skateboarders undergo a completely elastic head-on collision on the horizontal segment of the half-pipe. Treating the skateboarders as particles and assuming they dont fall off their skateboards, what is the height reached by each skateboarder after the collision? FIGURE P11.49
Two objects collide head-on (Fig. P11.39). The first object is moving with an initial speed of 8.00 m/s, and the second object is moving with an initial speed of 10.00 m/s. Assuming the collision is elastic, m1 = 5.15 kg, and m2 = 6.25 kg, determine the final velocity of each object. FIGURE P11.39