From chart (13-3) find Time of concentration by (minute) if: Distance of flow=14 m, Dense grass, ?slope=%1 14 min O 15 min O 11 min O -- : Time of concentration depend on slope , Ground Surface, slope of the sewer slope , Ground Surface , Runoff intensity slope , Ground Surface, slope of the sewer , Runoff intensity

From chart (13-3) find Time of concentration by (minute) if: Distance of flow=14 m, Dense grass, ?slope=%1 14 min O 15 min O 11 min O -- : Time of concentration depend on slope , Ground Surface, slope of the sewer slope , Ground Surface , Runoff intensity slope , Ground Surface, slope of the sewer , Runoff intensity

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1) Design a flocculation basin for water at 10°C flowing at Q = 49,200 m3/day for a typical process.train in a drinking water treatment plant. The basin shall be a cross-flow, horizontal-shaft, paddlewheel type with an average velocity gradient of G = 26.7 sec−1, a detention time τ = 45 minutes,and a Gτ value of 50,000 to 100,000. Tapered flocculation shall be used in three compartments ofequal depth in series. Compartments shall be separated by slotted, redwood baffle fences andhave a level basin floor. G-values shall be 50, 20, and 10 sec−1 as the water passes through eachcompartment sequentially. The flocculation basin shall have a width of 27.43 m matching theadjacent sedimentation basin width. Paddle wheels shall have blades with a 150-mm width and alength of 3.05 m. Outer blades should clear the floor by 305 mm and be 305 mm below the watersurface. Six blades shall be used per paddle wheel with a clear spacing of 305 mm between theblades. There shall be a clear spacing of 760 to…
OTO 'T Hydrograph Analysis • HW The baseflow in a stream and the 3-hour unit hydrograph for the basin are given below. Determine the total flow hydrograph for a storm of the pattern indicated. (1 t + ||| فلاتر Prepared by Dr.Nabil Al Aamery O Time (hr) 1200 1500 1800 2100 2400 0300 0600 0900 1200 1500 1800 Total 25 mm Excess 10.5 mm hr إضافة شرح... × 7 50 Unit Hydrograph (m) Baseflow (m³/s) 10 4.7 10 7.5 11 5.7 43 11 TI 3.1 12 24 12 14 12 0.8 13 0.2 13 13 (same baseflow continues) 35 mum 44
20
Q1// Use Manning's formula and employ Manning's coefficient (n) equals 0.016 to calculate the uniform flow velocity (fps) and capacity (gpm) of a 8-inch size sanitary drain installed at a slope of 14 in./ft and is half full.
Q5: A- Find the values of Le, Ki and K, from the given information using Thomas graphic method. BOD 12 19 21 25 27 30 (mg/L) Time 2 6. 9. (day) B- State and briefly explain the factors that influence the characteristics of the wastewater.
8 rapid sand filters are used to treat 35 MLD of water with rate of filtration 4000 lit/hr/m². If back washing rate is 4 times rate of filtration and duration of back wash is 15 minutes operated once in every 24 hrs, then the percentage of filtered water required to back wash the filter is
i have to submit this question ASAP can you please help me with it ? thank you
Problem 3. Given below are the daily mean flows in cubic meter per second at a gaging station for a period of 5 days. What is the mean flow rate for the period of cubic meters per second? What is the total discharge during the period in cubic meters? If the drainage area is 1958 km', what is the runoff volume in millimeters? Day 1 | 2 | 3 4 | 5 Flow, m'/s 19.8 135.9 87.8 57.2 37.1 Problem 4. Using the data of prob. 4-3, and relationship of Fig. 4-16, estimates the peak flow
Question
Determine the size of outfall sewer below Manhole 3 (MH3) needed to serve the drainage area in the following figure. Each area has an inlet time of 7 min. The coefficient of runoff for the 2 housing area 1 and 2 is 0.55 and area 3 is as asphalt pave area. The distance between manholes 1 and 2 is 300 meter and the pipe between manhole 2 and 3 is 500 meters. The velocity of water in pipes is 2.8 ft/sec. The rainfall intensity duration relationships is i=140/(t+16), where i=inch per hour and t=rain duration in minutes.
Q4: A rapid filter plant is to treat 28000 m³/d at a rate of 110 m/d. Determine the size and number of filters required. If the filtration rate is not to exceed 170 m/d with two filters being backwashed, nor 240 m/d with one filter out of service and two filters being backwashed. How much water would be required to backwash two filters if the wash is at 66 m/hr. and continues for 5 minutes.
Question - It was decided to construct a fabric filter, using bags of 0.45 m diameter and 7.5 m long, for removing industrial stack gas containing particulates. The expected rate of airflow into the filter is 10m3/s. If the filtering velocity is 2.0 m/min, the minimum number of bags (rounded to nearest higher integer) required for continuous cleaning operation is..