Four test tubes with 20mL of water and cut flowers were set up. Three of the test tubes had food coloring added. You observ the flowers that were placed in the test tubes for the following five days. You record your observations each day at 10:00am. On the fifth day, the flowers in the colored test tubes began to turn the color of the liquid in which they were placed. You hypothesis was: IF cut flowers are placed in colored water, THEN the flower petals will absorb that color throughout the petals. Experimental Design In this experiment, one of the constants was: O 10:00am O The test tube without food coloring O The ending color of the flowers O The color of the water

Four test tubes with 20mL of water and cut flowers were set up. Three of the test tubes had food coloring added. You observ the flowers that were placed in the test tubes for the following five days. You record your observations each day at 10:00am. On the fifth day, the flowers in the colored test tubes began to turn the color of the liquid in which they were placed. You hypothesis was: IF cut flowers are placed in colored water, THEN the flower petals will absorb that color throughout the petals. Experimental Design In this experiment, one of the constants was: O 10:00am O The test tube without food coloring O The ending color of the flowers O The color of the water

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A chardonnay wine is 13.5 percent by mass alcohol. If we consume 24 fluid oz of wine, and the density of the wine is 0.982 mg/mL, how much alcohol was consumed? 09.6 x 103 g alcohol O 301 g alcohol O 94 g alcohol O 106 g alcohol O 13.3 g alcohol
The physician orders an IV solution to infuse at the rate of 44gtt/min. The infusion set is calibrated for a drop factor of 5gtt/mL. How much of the solution will infuse during 2.5 hour? Round your answer to the nearest mL. mL
Suppose your instructor places a can of regular and diet cola in a large container filled with water. What might you expect happen based on the results of this experiment?
1. Several students performed this experiment without paying adequate attention to the details of the procedure. Briefly explain what effect each of the following procedural hanges would have on the size of the volume- to- temperature ratio calculated by the students. (a) One student failed to replenish the boiling water in the boiling- water bath as the flask was being heated. At the end of the 6 min of heating, the boiling water in the bath was only in contact with the lower portion of the flask. (b) Following the proper heating of the flask in the boiling water, a student removed the flask from the boiling- water bath but only partially immersed the flask in the ice-water bath during the cooling period. (c) A student neglected to close the pinch clamp before removing the flask from the boiling water bath and immersing it in the ice-water bath. (d) One student neglected to measure the volume of the flask before leaving the laboratory. Because the procedure called for a 125-mL…
A student prepares a 0.38 mM aqueous solution of acetic acid (CH3CO₂H). Calculate the fraction of acetic acid that is in the dissociated form in his solution. Express your answer as a percentage. You will probably find some useful data in the ALEKS Data resource. Round your answer to 2 significant digits. 11 % 0.0 x10 X S 0 E
I’m stuck in this those question To make 1L of 250mM NaCl, I would add ——-grams of NaCl to a graduated cylinder and bring the volume to ——-mL. To make 50mL of 2% NaCl, I would add ANSWER grams of NaCl to a graduated cylinder and bring the volume to ANSWER mL. To make 200mL of 1x solution from a 10x stock, I would add ANSWER mL of 10x stock to a graduated cylinder and bring the volume to ANSWER mL.
In lab, a student was given a hydrated version of Ba(OH)2 as the unknown. The initial mass of the hydrated salt was 0.848 g. The student heated the crucible for 10 minutes with the cover slightly ajar. After cooling, the dried salt weighed 0.767 g. Based on these results, answer the following questions. The chemical formula for this hydrate is: Ba(OH)2⋅Ba(OH)2⋅ ___H2O The IUPAC name for this hydrate is:
A solution is prepared by mixing 20.0 mL of 0.1 00M Fe(NO3)3 with 20.0 mL of 0.00300M KSCN and 10.0 mL of DI water. Calculate the initial concentration of SCN^- in this solution? Give answer with correct amount of significant figures.
You want to compare a patient's measured calcium ion concentration to the normal calcium ion concentration in blood serum. The only range you can find is 4.5 - 5.5 mEq/L, but the blood results show a concentration of 0.22 mmol/dL. Convert the measured calcium ion concentration from the blood results to mEq/L (to one decimal place). What are the units?
A chemistry student weighs out 0.0960 g of phosphoric acid (H,PO4), a triprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.1100 M NaOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Round your answer to 3 significant digits. |mL ola х10 Ar
5. The Malaysia National Standard for total amount of lead (Pb) in drinking water is 10 µg/L. Two laboratories reported average results for the analysis of two mineral water samples, which were 2.25 mM (sample A) and 1.05 x 10-5 % (in w/v, sample B). Based on the obtained data, decide if it is safe for you to drink the water?
An analytical chemist weighs out 0.264 g of an unknown diprotic acid into a 250 mL volumetric flask and dilutes to the mark with distilled water. He then titrates this solution with 0.1900M NAOH solution. When the titration reaches the equivalence point, the chemist finds he has added 18.5 mL of NaOH solution. Calculate the molar mass of the unknown acid. Round your answer to 3 significant digits. x10 mol