Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW, 6000 kW, 2000 kW and 7000 kW respectively. Determine the best location of the substation for feeding these loads. The reference point of load is 4000 kW.

Q: Design a controlled half wave rectifier circuit to produce an average of 30 V across a 250 ohm load…

A: In this question we need to design a controlled half wave rectifier circuit to produce an average of…

Q: Hydro power plant costs Tk. 45×101º with maximum capacity of (x+6) MW.

A:

Q: Which of the following statement is wrong for the outdoor substations? O For voltages below 33 KV O…

A: The voltage ratings of outdoor substations usually lies between 55KV to 765KV .

Q: Problem 3 A climate control system, a motor load, and a lightning circuit of a small warehouse…

A: Step 1: Given data and solution to part a,b Step 2: Solution to part c

Q: The indication of a lagged demand meter approaches the value of the actual load at a rate which is…

A: Concept- A lagged demand meter- The pointer is made to move in the electromechanical thermal or…

Q: Q A power station with capacity of 800 kW is to supply two loads (A & B). The daily load curve of…

A: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining part…

Q: The distribution of loads among the generating units is called as unit commitme Select one: O True O…

A: What about true and false statement about the given statement?  The distribution of loads among the…

Q: Explain the reliability of power supply in the distribution system. Justify your answer with real…

A: Reliability denotes the ability of a distributed system to deliver its services even when one or…

Q: During brown-out, the building has 2 gen-set reserve to supply its needs of 1 200 kW. Gen-set A is…

A:

Q: A power station is to supply two loads. The daily load curves of two loads are shown in figure…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: A power station is to supply two loads. The daily load curve of the station is as shown in figure…

A: Given: A power station which is supplying two loads and the daily load curve. Also the load factor…

Q: Q1//A power plant has to meet the following load demand: Load A: 100 MW from 8 AM - 6 PM Load B: 150…

A:

Q: A power station is to supply two loads. The daily load curve of the station is as shown in figure…

A:

Q: A motor load of a workshop and a wood shaper establish a 22 kVA power demand at 50 percent lagging…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: 7. A power station has to meet the following load demand : 50 kW Load 4 between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: Explain why higher the load factor of the power station, lesser will be the cost per unit generated

A: Load factor is the ratio of average load to the peak load during a certain period of time. For a…

Q: The maximum demand of a power station is 15 MW. Annual load factor is 50% and capacity factor is…

A:

Q: A generating station has an average demand of 15 MW. If the plant capacity factor is 50 %, what is…

A: Given, Average demand = 15 MW Plant capacity factor = 50 % = 0.50

Q: A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL…

A: The substation is an electrical substation is a subsidiary station of energy technology,…

Q: QI//A power plant has to meet the following loud demand: Load A: 100 MW from 8 AM - 6 PM Load B: 150…

A:

Q: QI/A power plant has to meet the following load demand Load A: 100 MW from 8 AM - 6 PM Load B: 150…

A: The solution can be achieved as follows.

Q: 1. Explain the reasons for the low power factor in the power system network

A: Power factor (PF) is the ratio of working power, measured in kilowatts (kW), to apparent power,…

Q: 4- For the transformers operating in parallel prove the following: a- The circulating current…

A: Electrical machines can be either generator , motors or transformers. They can be either Ac machines…

Q: The variation of the load is considered over a period of month in the monthly load curve.…

A: True The monthly load curve can be obtained from the daily load curves of that month. average values…

Q: Choose the supply voltage for a step down chopper circuit which drives the resistive load 4.8Ω with…

A: Given, R=4.8 ΩI0=32.4 AD=0.4 where. R is the resistance of load, I0 is the average load current and…

Q: Power system

A: According to question: The sag in the transmission line is calculated as…

Q: Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW,…

A: Given information: The length of the side of the square is 26 km.  If A, B, C and D represent the…

Q: ) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20…

A: Capacity factor =Average load / installed capacity. Average load = no. Of units produced / no. Of…

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

A:

Q: (ii) transmission efficiency. [(i) 10.46 kv (ii) 207 A (ii) 95%] 6). A short 3-0 transmission line…

A:

Q: The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two…

A: Advantages of three-phase system over a single-phase system: Greater power output: A three-phase…

Q: QI/A power plant has to meet the following load demand: Load A: 100 MW from 8 AM - 6 PM Load B: 150…

A: Plant daily load are given in the table.  Plot the daily load curve, diversity factor Load factor…

Electrical Power Generation

In an electric power generator, one type of energy is converted into electrical energy. Power-generating systems are simply a combination of potential or stored energy that is converted to provide kinetic energy, which, in turn, generates electrical energy for use in engines, lighting, heating, and other benefits of modern life.