For this question you are to sketch two transformers (T1 and T2) side by side connected in PARALLEL. Be sure to employ alphanumeric polarity markings for each transformer with the LV windings on the TOP and the HV windings on the BOTTOM. T1 should have ADDITIVE polarity and T2 should have SUBTRACTIVE polarity. Include a source bus voltage [REFERENCE) above the transformers and a single-phase load. Indicate the direction of all voltages with respect to the reference direction. Based on the preceding requirements, provide a complete SCHEMATIC diagram showing how the two transformers should be connected for proper PARALLEL operation.

For this question you are to sketch two transformers (T1 and T2) side by side connected in PARALLEL. Be sure to employ alphanumeric polarity markings for each transformer with the LV windings on the TOP and the HV windings on the BOTTOM. T1 should have ADDITIVE polarity and T2 should have SUBTRACTIVE polarity. Include a source bus voltage [REFERENCE) above the transformers and a single-phase load. Indicate the direction of all voltages with respect to the reference direction. Based on the preceding requirements, provide a complete SCHEMATIC diagram showing how the two transformers should be connected for proper PARALLEL operation.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The algebraic symbol for the number of turns on the high voltage side of the transformer is_____. A) Th, B) TX, C)T-Primary, D) T-Secondary. The algebraic symbol for the current through the low voltage winding is ____. A) IH, B) IX, C) I-Primary, D) I-Secondary Whic of the following is information that is found on an AC generator's nameplate? A) voltage, current, B) frequency, number of phase, speed rating, C) maximum temperature rise, excitation requirements, D) all of the above
What happened to 3-phase delta configuration of transformer when any one of the phases is opened due to the fault. Also, explain a brief operation along with the appropriate phasor diagram. Draw the phasor diagram along with the connection for Dd6 and Ydi
Consider the three single-phase two-winding transformers shown in Figure. 3. The high-voltage windings are connected in Y. (a) For the low-voltage side, connect the windings in A, and label the terminals a, b, and c in accordance with the American standard. (b) Relabel the terminals a', b', and c' such that VAN is 90° out of phase with V₂'b' for positive sequence. DI H₂ Figure. 3: Three-Winding Transformer
I need the answer as soon as possible
In small transformers, the total copper loss may vary from the rated output. % of O 0.2 to 0.6 O 0.5 to 1 O 0.8 to 1.5 O 0.4 to 1
63/ Choose the incorrect statement of a no load single phase transformer from the following a. The primary induced emf (E1) is in phase with the secondary induced emf (E2) b. The no load current (Io) leads the core loss component of no load current (Ic) c. The no load current (Io) lags the core loss component of no load current (Ic) d. The secondary induced emf (E2) lags the magnetic flux by 90 degree
A 50 Hz, Scott connected transformer supplies an unbalanced two phase load at ( 400 V) per phase. For the leading phase the load has a resistance of (13.3 ohm) and capacitor of (318) micro farad in series. For the other phase the load consists of resistance (10) ohm and an inductance of (42.3) mH. Calculate both mathematically and graphically the lines currents on 3-phase side. The main transformer primary to secondary turns ratio is (12/1).
Choose the correct statement of a no load single phase transformer from the following O a. The magnetizing component of no load current (Im) leads the core loss component of no load current (Ic) O b. The magnetizing component of no load current (Im) lags the core lossComponent of no load current (Ic) O c. The magnetizing component of no load current (Im) and the core loss component of no load current (Ic) are in phase each other O d. The magnetizing component of no load current (Im) leads the core loss component of
2.Fringing effect is a phenomena occurs in .. (a)Transformers. (bElectrical field. (e)Air gap (d)All of the above. 3, The kVA rating of an ordinary 2-winding transformer is increased when connected as an autotransformer because (@ transformation ratio is increased (b) secondary voltage is increased (c) energy is transferred both inductively and conductivity (d) secondary current is increased. 4. The .... of the hysteresis loop is a measure of energy lost per cycle (a) area. (b) Туре. (c) Frequency (d) No one of the above. 5. At relatively light loads, transformer efficiency is low because (a) secondary output is low (b transformer losses are high (c) fixed loss is high in proportion to the output (d) Cu loss is small. 6. In an ideal transformer, (a) windings have no resistance (b) core has no losses (c) core has infinite permeability (d) all of the above. 7. In electromagnetic circuits, path of eddy current is.... (a) Parallel to the path of the flux. (b) Perpendicular to the path of…
A 36/240 V phase transformer, belonging to a phase measured from the no-load (idle) run and short-circuit test. values are given in the table below. High voltage by applying rated voltage to the low voltage winding (The winding ends were left unloaded and the results of the no-load test results were obtained. By applying nominal current to the high voltage windings, the low voltage windings were short-circuited, and the results of the short circuit test were obtained. In direct current test 1 V direct voltage is applied to the low voltage winding, and the transformer draws 500 A direct current. All equivalent Calculate the circuit elements as moved to the low voltage side. Idle run test: Voltage : 36V Power : 68W Current : 2,8A Short circuit test: Voltage : 15V Power : 325W Current : 42,2A
Q5:Choose the correct answer from the given alternatives (answer five only) 1.In an ideal transformer, (a) windings have no resistance (b) core has infinite permeability (d) all of the above. (c) core has no losses 2. The primary and secondary induced e.m.fs. El and E2 in a two-winding transformer are always: (a) equal in magnitude (b) in-phase with each other (c) antiphase with each other (d) determined by load on transformer secondary. 3. In relation to a transformer, the ratio 20 : 1 indicates that (a) there are 20 turns on primary one turn on secondary (b) secondary voltage is 1/20th of primary voltage (c) primary current is 20 times greater than the secondary current. (d) for every 20 turns on primary, there is one turn on secondary. 4. A transformer has negative voltage regulation when its load power factor is: (a) zero (b) lagging. (d) unity (c) leading
In no load Phasor diagram of practical transformer, the core loss current Ic is with primary voltage Vp. O Lagging O in phase O Leading O 90 degrees out of phase