For the welded tension member shown in the figure,determine the shear lag factor, U; the net area, An; and the effective area, Ae; the Tensile Yielding strength, Pn(y); and the Tensile Rupture strength Pn(r).

Q: toonges as aasm 12 mm thick plate is conected to two 8 mm thick plates, on either side through a 16…

A:

Q: 6. Value of Young's modulus of elasticity of steel if , Bulk modulus is 160 GPa and Poisson's ratio…

A:

Q: The plates in the figure below are each 3 inches by 0.5 inches in cross section. If the hole in each…

A: Solution:- Given information: Cross section of plate =3×0.5 in Hole diameter, d=1316 in, and Load,…

Q: What would be the temperature at which the bar will have a compressive stress of 3 MPa given that at…

A: Elongation due to temperature change δT=Lα(ΔT)ΔT=T2-T1=T2-(-20)=T2+20

Q: When the normal stresses are at their maximum or minimum values, the shear stresses are zero. We can…

A: 1- Yes when normal stresses are maximum or minimum, then at that element shear stress is zero. 2-…

Q: Part A If the bolt is subjected to a compressive force of P = 21.9 kN, determine the magnitude of…

A: Length of bronze and steel rod is same.The change in length of steel is equal to the change in…

Q: The aluminum bar ACDB is rigidly connected to a steel tube in CD. The data is presented in the…

A: Detailed step by step solution is given below, still if you have any query please feel free to…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.