For the system shown in the Figure, Reservoir 1 has a water depth of 6 m and Reservoir 2 has a water depth of 14 m. The bottom of Reservoir 2 is at an elevation of 19 m above the bottom of Reservoir 1. The pump is required to deliver 400 l/s of water from Reservoir 1 to Reservoir 2. Given that the total energy loss in the system is 1 J/N, how much power must the pump deliver? Give your answer in kW to one decimal place. Reservoir 2 pump Reservoir 1

Q: Q2: It is required to pump cooling water from storage pond to a condenser in a process plant…

A:

Q: If the velocity of water is 8.5 m/s and the pressure is 135KPA on the discharge side of a pump. a.…

A: Given that At discharge side P2 = 135 KPaV1 =8.5 m/s

Q: Q23:- In hydraulic power generation process, water at 30 psia is falling from an elevated point at a…

A:

Q: A hydroelectric turbine produces 50 m of head with a flow rate of 1.30 m³/s. The overall turbine-…

A: Given data: Head; h=50 mFlow rate; Q=1.30 m3/sEfficiency; η=78%=0.78Density of water; ρ=1000…

Q: Q4. 1600 cm/s of glycerol is to be pumped through a commercial steel pipe, 2-inch diameter and 30 m…

A: given  I-solution-glycerol mass flow rate m=1600 cm3/s =0.0016 m3/s steel pipe- d=2 inch =0.0508 m…

Q: Gasoline (SG=0.68) flow through a pump at 0.12 m³/s as shown Q - 0.12 ms Section (2) D2 = 0.2 m 3 m…

A: Given: The specific gravity of gasoline is SG = 0.68 The density of water is 999 kg/m3, thus, the…

Q: water at 20 c is being delivered from pump through a coaxial annular smooth at a rate of 0.91…

A:

Q: 4.8. In a power plant, the inlet water has a velocity of 100 ft/s and an elevation of 80 ft above…

A:

Q: 1. Water at 20°C and a steady-state rate of Q = 0.050 m³/s is flowing through a reducing pipe bend…

A: The temperature of water flowing through a reducing pipe, T = 20°C Steady-state volumetric flow rate…

Q: A centrifugal pump is used to pump water through horizontal distance of 150 meters and then raised…

A: Given: Length of the pipe=150 m The overhead tank length=20 m Inside diameter of pipe =50 mm=0.05 m…

Q: A centrifugal pump is used to pump water through horizontal distance of 150 meters and then raised…

A: Horizontal distance  = 150 m Overhead tank distance after pump = 20 m  Pipe inside diameter (d) = 50…

Q: If the propeller in this problem is replaced by a six-bladed turbine of 400 mm diameter, and the…

A: Given,

Q: A centrifugal pump is tested at 1750 rpm using flow system with a layout. The water level in the…

A:

Q: A hilltop subdivision takes water from a river 500 ft below it during the night through a pump…

A:

Q: 1. The energy from masses of flowing water such as in a river is a type of renewable energy source.…

A:

Q: Q2) Consider the large tanks system shown in Figure Q2. Determine the level of water in tank 1, ha.…

A: Diameter of pipe at the exit of tank A = 0.03 m Diameter of pipe at the exit of tank B = 0.05 m…

Q: Consider the transmission case of Problem 1.23, but now allow for radiation exchange with the…

A: Given Data:Pi=150 hPTsur = 30oCThe emissivity () is 0.80.W= 30 mThe efficiency ()is 0.93.

Q: Q28:- Water is being pumped at a rate of 0.5 ft'/sec from a storage tank to a certain exit point of…

A:

Q: Liquid isobutane at T=160 °F and pressure P=500 psia with a flow rate of m = 1000 lbmol/hr is sent…

A:

Q: Water is flowing through a horizontal 6 in. Schedule 40 mild steel pipe at 1 atm and 25°C. The…

A: Given:The roughness factor, The inside diameter, The length of the pipe, The inlet pressure, The…

Q: Helium is compressed in a continuous flow compressor. The speed at the compressor outlet is 32 m/s,…

A:

Q: The reservoir problem containing 45 kg of liquid with an initial temperature of 45 ° C has one inlet…

A:

Q: P.15.5 Water (sp. gr = 1) is pumped through a heat exchanger and control valve. At normal…

A: Given - At normal conditions, the flow rate is.. pressure drop across the control valve at normal…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: Water at 28 ºC flows into a straight horizontal duct, there is no downloading of calories or work…

A: Given data: Initial temperature of water = 28 0C Initial velocity of water = 8 m/s  Internal…

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: For the conditions and geometry shown in the figure below, calculate the time it takes to completely…

A: Height of tank = 4 m  Diameter of pipe = 0.8 m Diameter of tank = 2 m Fluid is water U1 = 2.6 (1 -…

Q: Example (4-2): A pump is 2.2 m above the water level in the sump and has a pressure of (-20) cm of…

A: Vacuum pressure at the suction side of the pump = -20 cm of the mercuryDiameter of the suction pipe…

Q: The small turbine in figure D extracts 400 W (assume efficiency equal to 1) of power from the water…

A: Given: ρ=1000 kg/m3ν=μρ=1.02×10-6m2sD1=0.05 mD2=0.03 m

Q: Calculate the required number of turbines we need in a wind farm generating 1MW if each turbine has…

A:

Q: In the above example problem, a hydroelectric turbine at the base of a dam is shown schematically.…

A:

Q: The mass flow rate of the gas in a gas turbine is 40kg/s. The specific enthalpy and velocity in the…

A: