For the power system shown below, find the p.u. values on the and 300MVA base. G1, G2: 300MVA 20 KV G3, G4: 250MVA 3.8 KV T1, T2: Т, Т: XTL= X= 10% X= 20% 300MVA 20/400 KV X= 15% 200MVA 3.8/400 KV X= 10% 25 Ω T1

Q: Calculate the actual current 1₂ for this following line diagram: SB 100 MVA. 30 60 Hz 13.8 kV T1 30…

A: Given line diagram is,Asked to find the current I2=?

Q: V1 = V2 = 202 V3 = www 3 2290° A220° V 42 4Ω Find the SAE's for the assigned nodal voltages. Solve…

A:

Q: 3 2 + V2 is v5 70 24 V + Vi

A: We need to find out current and voltage and power for given circuit

Q: Find the unknown quantities for the circuits below using the information provided. E + V₁ www 1A 202…

A: 1. First circuit diagram -2. Second circuit diagram -

Q: 2. Determine the inductance at terminals A-B in the network in the follow diagram: ' 1mH 1mH 2mH…

A: In this question we need to find a equivalent inductance between the two terminal of the given…

Q: R1 12 I1 102 C1 1/30 2 Cos 3t Ampere 2 Sin 3t Ampere F

A:

Q: Problem: Find the Open-circuit Voltage at terminals a-b, and the Short-circuit Current between…

A: In this question, we need to determine the open circuit voltage and short circuit current across the…

Q: Measure currents for unbalanced load

A: In the given circuit, the 3-phase source(s) and load element(s) both are connected in star-form.

Q: Question 13 Using the Node Voltage Method, what is the current I,? -j40 j4 0 ll V1 10430° V 102-30°…

A: Right Answer  Option 2.5∠0°

Q: For the circuit shown, the total power is: IT = 14.5 A 가 I1 = 5.6 A R1 = 250 Multiple Choice R2 =…

A:

Q: Find all the missing quantities. Show your work. Determine the total resistance for the circuit.

A: The unknown quantity of the given circuit needs to be calculated and the same can be calculated by…

Q: Refer to figure below. E = 230 V/0° f = 50 Hz (~ 661.25 W 2.875 W OW XL = 40 2 Determine the real…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.