For the circuit shown, the total power is: IT = 14.5 A 가 I1 = 5.6 A R1 = 250 Multiple Choice R2 = 802 12 = 11.75 A R3

Q: d 2023 2 A 0.5 A 492 8 Ω 5 V www 1092 V If V 11 V, determine the node voltages v₁ and v2. (Round the…

A: In this question We need to determine the voltage V1  and V2  as shown the circuit.  If V= 11V

Q: V1 250 V .84 €7.5Ω Τ ix 102 V2 1Ω {2.5Ω €124.

A:

Q: Question 1. Refer to figure below. E-230 V/0° f=50 Hz Determine the current 7₂. 2.875290* A…

A:

Q: Calculate the lx current using the constant voltage model for the circuit in the figure. Şekildeki…

A:

Q: For the following electrical circuit in R3 = 649ohm determine by the method of Superposition…

A: Given:a circuit, we need to determine:The electric current, Voltage and Power dissipated in R3 = 649…

Q: Compute the current through and voltage across each resistor using Source Transformation or Mesh…

A: here we have to calculate the voltages and currents across each resistor using mesh analysis.

Q: Four No. 12 and four No. 10 conductors are to be installed in a EMT conduit. What size EMT conduit…

A: Conductors size is selected on the basis of assigned numbers.  As the assigned number increases then…

Q: On the circuit of problem 12. What is the current flow across the resistor R2 86.32 ma 34.51 ma O…

A:

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.