Answered: For the pin-connected structure,…

For the pin-connected structure, determine the minimum diameter for the pin at joint D if the average shearing stress in the pin must be limited to 7500 psi.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The Mohr's circle shown has coordinates X = (60 MPa, -16 MPa) and Y = (0 MPa, 16 MPa). Draw the stress element for maximum shear at the correct orientation (label the new axes, the magnitude and direction of the stresses and show the angle). (Upload your answer showing all values as well as neat and clear calculations) Y
show complete solution
Question 5 Match the answers in the columns. v Maximum Shear stress of a cross section. A. using an l-section instead of a rectangular section. v Maximum Bending stress of a cross section. B. Tension and bending force. C. 1m form the supports - v If a simply supported beam is subjected to a distributed load, where are you most likely to find tension bending cracks. D. At Midspan - v Ifa simply supported beam is subjected to a distributed load, where are you most likely to find shear cracks. E. Midspan at the bottom v The bending stress in a section can be reduced by using a F. Midspan at the top v Shear stress can be increased by the width of a section. G. At the supports. v The shear force in fasteners. H. Reducing the width of a section. v Moment couple on a section. 1. using a rectangular section instead of an l-section J. Shear flow K. Increasing the width of a section. L. Only at the section sides touching the NA M. In between the NA and the top/bottom fibres N. Usually at the NA…
Three plates are welded together to form the section shown. Dimensions of the cross section are b= 4.7 in., d = 14.1 in., a = 2.8 in., and t= 0.5 in. For a vertical shear force of V = 42 kips, determine the shear flow through the welded surface at B. B a b Answer: kip/in.
0.15
Steel type is W310 X 74. P1= 40kN P2= 30kN. Find principal stress and shear stress at point '' a '' and '' b''
Three plates are welded together to form the section shown. Dimensions of the cross section are b = 6.0 in., d = 18.0 in., a = 4.0 in., and t = 0.7 in. For a vertical shear force of V = 34 kips, determine the shear flow through the welded surface at B. d B a
3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear stress for the material is T= 300 MPa. Pin A is subjected to doble shear, whereas pin B is subjected to single shear. A 1.5 m B 1.5 m C D 30 kN 2.25m
The bell-crank mechanism is in equilibrium for an applied load of F1 = 11 kN applied at A. Assume a = 250mm, b = 100mm, c = 90mm, and θ = 40°. Pin B is in a double-shear connection and has a diameter of 29 mm. The bell crank has a thickness of 31 mm. Determine the shear stress in pin B and bearing stress in the bell crank at B. Express your answer in MPa rounded to the nearest hundredths.
SITUATION. Determine the value of 0 if the shearing stress on the glued joint is thrice that of the normal stress.
A truss system is supported by two pins at the top. Determine the absolute value of the axial stress in member AC (in MPa) if the diameter of the member is 30 mm.
13