For the pair of 26-lb forces applied to the handles of the crimper tool, determine the crimping force in the jaws at G. 1.50 23° 0.65 Answer: FG-1 2.75" 6.25"- 6.75" 0.65" 0.25" 0.40" D 26 lb B 26 lb

Q: Shown below is a toggle clamp that exerts only a vertical clamping force on the wood block at A.…

A: The force is The length of handle is

Q: Determine the magnitude and sense of the loves. in members A and B. A 1201bs 450 B 2001bs 102 300 E

A: The forces and there orientation are given

Q: Calculate the magnitude of the force acting on the pin at D. Pin C is fixed in DE and bears against…

A: The horizontal force acting at point B:And from the given figure:Distance between the point A and…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: The force perpendicular to BC is

Q: Consider the clamping device used to lift a 55 gallon drum, as depicted in the accompanying figure,…

A:

Q: Q1: Determine the magnitude of the force on the pin at A for the boom shown in Fig. 1. Neglect the…

A:

Q: Determine the force in member AB of the truss. Express your answer in pounds to three significant…

A:

Q: Determine the magnitude of the force which member CD exerts on the pin at C. A 1299 B 0.62 m Answer:…

A: According to the given data A loading structure ABCD  We need to find Force on a pin at C by the  CD…

Q: 1. (1 point) If F is in the -y direction and has a magnitude of 4kN, what is the force in bar A A.…

A: GivenF=4kN

Q: The truck shown is used to deliver food to aircraft. The elevated unit weighs 2400 lb vwith center…

A:

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: P2: The 50-lb rectangular access door is held in the 90° open position by the single prop CD.…

A: Given:Mass = 50 lbAngle = 90 0

Q: The frame for a sign is fabricated from a thin, flat steel bar stock of mass per unit length 4.73…

A:

Q: Situation 5. Determine the forces in cables AC and AB needed to hold the 20-kg ball D in…

A: GivenF=300Nm=20kgd=1m

Q: . Determine the eccentricity and location (indicate your eference force) of the force on the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.