For the next two questions, consider the spring-mass system shown below. The system consists of two bodies of mass on three springs. Damping is assumed to be practically zero. X2 k2 14 5. The linear system from the previous question can be transformed into an eigenvalue problem to solve for the solutions a1 and x2 by assuming a trial solution æ = aeut. if k1 = k2 = k3 and m1 = m2 = 1kg, which of the following are the eigenvalues? {2k, k} {-2k, -2k} {-3k,-k} {3k, k}

For the next two questions, consider the spring-mass system shown below. The system consists of two bodies of mass on three springs. Damping is assumed to be practically zero. X2 k2 14 5. The linear system from the previous question can be transformed into an eigenvalue problem to solve for the solutions a1 and x2 by assuming a trial solution æ = aeut. if k1 = k2 = k3 and m1 = m2 = 1kg, which of the following are the eigenvalues? {2k, k} {-2k, -2k} {-3k,-k} {3k, k}

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. A 3 kg object is attached to spring and will stretch the spring 392 mm by itself. There is no damping in the system and a forcing function of the form F(t) = 10 cos (17t) is attached to the object. If the object is initially displaced 20 cm downward from its equilibrium position and given a velocity of 10 cm/sec upward find the displacement at any time t. Show graph.
System is damped single degree of freedom and under a harmonic loading. There are 5 different F(t) funcitons. Find equation motion for each functions and draw graphis for one of them.
5 Problem Consider the damped harmonic oscillator shown below and modeled by the system: b m (1) with mass m = 1 kg, spring stiffness k = 100 N/m, and initial conditions x(to) = 0.1 m and x(to) = 0, where x(t) is the displacement of the mass from the nominal (unstretched) spring position. Four dashpots are being considered for this system: D1, D2, D3 and D4 have damping coefficients b₁ = 3, b2 = 10, b3 = 20, and b4 = 50 N/(m/s), respectively. Pneumatic Dashpots: D1 D2 end * + D3 D4 x + m x=0 Assume: Horizontal Plane (no gravity) x(t) bu m www k You are tasked with selecting the correct dashpot that renders the system critically damped and to determine the response of the system over a two second interval from the initial condition. To perform your analysis, include the following: • A single plot with all five curves showing the response of the system to the initial conditions for each dashpot over a two second interval, and for the case of no dashpot b = 0. Each curve should be plotted…
Please answer it with step by step solution. Thank you and advance Merry Christmas!
Let e be the counterclockwise angular displacement of the disk in the following system. a) Derive the governing differential equation of the system by using the Newton 2d law. b) Find the natural frequency of the system c) For what value of c is the damping ratio of the system equal to 1.15? fy-10 cm f30 cm m2 m1 Jputey10 kg-m m;-10 kg my-25 kg k-1x10' N/m
in this question m=6
4- The logarithmic decrement can be obtained as & In, is it possible to get a negative value of 8 when the system is damped (<1)? Why?
ASAP
1. Equation of Motion 2. Find the response of the system, as the initial condition is (X, = 2 cm at the block). %3D Note: m= 1kg, Mlise 3 kg, c=50 N-s/m, k 200 N/m, and r= 10 cm. %3D and determine the response after 10 sec. 2r Activate
Q4: - Using Laplace transforms to Find the displacement equation of mass (3 kg) attached with three elastic springs (1, 3, 2.25) N/m respectively as shown in Figure if the system vibrates from rest under critical damping. ell
You have a prototype Slinky with a lump of coal at the end. This forms a damped spring-mass system. Assuming the usual units you may suppose the mass of the coal m=1, k=3, and the damping constant b = 1. Write down an ODE that models the behavior of this system. If you stretch the spring 1 meter and let it go with no initial velocity, determine the position of the mass after t seconds. At t=4 seconds you whack the mass with a giant candy cane imparting 5 units of impulse. Keeping the same system and the same initial conditions, now determine the position of the mass aftert seconds. PLEASE ANSWER THE LAST QUESTION. (At t=4 seconds you whack the mass with a giant candy cane imparting 5 units of impulse. Keeping the same system and the same initial conditions, now determine the position of the mass after t seconds.)
3. A 100-pound weight is suspended from a vertical spring whose module is 100 pounds per foot. The weight is pulled downward 9 inches from its equilibrium position and released. Viscous fluid exerts 20 Ibs of force when the plunger moves through it at 0.5 ft/sec; 3.a What is the damping condition? Write the equation which describes the motion of the weights. Show graph. 3.b displacement 3.c velocity 3.d acceleration