For the frame shown, the wood has a normal failure stress of 42 MPa, and a shear failure stress of 10 MPa. If P = 40 KN and the factor of safety against failure is 2, Determine the required minimum thickness t of member AB. a. 19.76 mn 18.76 In b. 16.76 mm 17.76 mm Determine the required minimum edge distance b. c. 73.56 mm d. 43.56 mm a. 53.56 mm b. 63.56 mm

Q: Link AC is made of a steel with a 65-ksi ultimate normal stress and has a 14  ×   1214⁢  ×   12 -in.…

A:

Q: A short column is made by nailing two 1 * 4-in. planks to a 2 * 4-in. timber. Determine the largest…

A: Given Data: The top surface area of center plank (A) is of (2 inchx4 inch) The top surface area of…

Q: 1. The structure is used to support a distributed load of w = 15 kN/m. The bolts at A, B, and C each…

A:

Q: The simply supported beam is built up from three boards by nailing them together as shown. Im 1 m…

A: find the allowable spacing of the nails.

Q: A rectangular column is made of a grade of sawn wood that has an adjusted allowable stress for…

A: Write the given data. σC=8.3 MPaE=11.1 GPaP=105 kNe=0.025 mb=0.180 md=0.240 m

Q: For the truss shown, the working stresses are 20 000 psi in tension and 12 000 psi in compression.…

A: From guidelines first question will be done from multiple questions posted. Please post again for…

Q: A rectangular column is made of a grade of sawn wood that has an adjusted allowable stress for…

A: Write the given data. σC=8.3 MPaE=11.1 GPaP=88 kNe=0.025 mb=0.180 md=0.240 m

Q: b. A draw bar between a tractor and a trailer is made from a length of steel with a rectangular…

A: Given Data

Q: A 50' length of steel rail is laid on a day when the temperature is 30 "F. In order to prevent rail…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.