For the following Pump curve: 100 80 Head * 60 40 Efficiency 400 800 1200 1600 2000 2400 Flowrate, gal/min What is the maximum efficiency in % that this pump can operate? What is the flowrate in gpm at the maximum efficiency? Head, It Eficiency, % 20

Q: A 2 cm diameter, 5 cm long capillary-tube viscometer is being used to measure viscosity of a 10 Pa s…

A: From the Poiseuille law: Q=πPr48ηl      ...(1) Q= Flow rate    = 1 kgmin×1 min60 S    =160 kg s-1 η…

Q: Water at 40 °C is pumped from an open tank through 200 m of 50mm diameter smooth horizontal pipe as…

A: The objective of the question is to calculate the power supplied to the pump, the Net Positive…

Q: Q4. 1600 cm/s of glycerol is to be pumped through a commercial steel pipe, 2-inch diameter and 30 m…

A: given  I-solution-glycerol mass flow rate m=1600 cm3/s =0.0016 m3/s steel pipe- d=2 inch =0.0508 m…

Q: A coaxial tube exchanger is operated under the following conditions. Tout K Cold fluid Hot fluid m…

A: Given, The mass flow rate of cold fluid, m˙c = 0.125 kg/s The mass flow rate of hot fluid, m˙h =…

Q: An oll (SG = 0.9) issues from the pipe shown in the figure below at Q= 35 ft/h. The length of the…

A: Write the energy balance equation for the given process as follows: P1ρg + v122g + z1 = P2ρg + v222g…

Q: P.15.8 Water is pumped through a heat exchanger and control valve. At maximum conditions, the…

A: Given, maximum flow rate isFractional opening flow area at normal condition is Relation between flow…

Q: If a cylindrical stirred tank bioreactor is scaled up from 1 L to 10,000 L at constant tip impeller…

A: The initial volume of the cylindrical stirred tank bioreactor, V1 = 1 L The scaled-up volume of the…

Q: In a turbo machine handling an incompressible fluid with a density of 1000kg/m3 the conditions of…

A: Given,the inlet pressure is, The exit pressure is, The inlet velocity is, The exit velocity is, The…

Q: A centrifugal pump discharged 0.019 m /s of water against a head of 16.8 m when the speed was 1,500…

A: Present problem is based on pump law that can be expressed as  For Flow rate, Q2 / Q1 = (n2/ n1)…

Q: Predict: (a) Gas kinematic viscosity. (b) Condensate gas flow rate in Ft/hr.

A:

Q: Calculate in 16/hr and the mass flow rate For 5000 BPD API=11.5

A:

Q: P.4.14 Water (density 1000 kg/m', viscosity 1 mNs/m²) is pumped through a 50 mm diameter pipeline at…

A: Case 1: Flow of water through pipe Mass flow rate of water, mW = 4 kg/s Diameter of the pipe, d = 80…

Q: Write the assumptions thats need to be taken ...

A: It's important to remember that these are general assumptions. Depending on the specific…