For the following problems, you are given a network address and asked to add subnet bits to produce a given number of subnets. Figure out how many subnet bits you need as well as the new prefix. Given

For the following problems, you are given a network address and asked to add subnet bits to produce a given number of subnets. Figure out how many subnet bits you need as well as the new prefix. Given

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Show the shortest and original (unabbreviated) form of the following addresses. a.…

A: We are given few IPv6 addresses and we are asked to show the shortest and original forms of the…

Q: 2 Performance / TCP A L1 Consider the following network: R L2 B Assume the network uses packet…

A: A networking technology and communication technique called packet switching involves dividing data…

Q: "An application message is segmented into 20 packets, each of which is 2500 byte in sze. Calculate…

A: Answer: This question from computer network I have given answered in the handwritten format

Q: The figure shows a TCP transaction. Assume Host A always has data to send, and each packet has size…

A: A) Here since 2nd packet is lost, ACK#1 = ACK#2 = ACK#3 =100 (sequence number of 2nd packet)…

Q: Consider a router that interconnects three subnets: Subnet 1, Subnet 2 and Subnet 3. Suppose all…

A: Given Prefix 223.1.17/24. Subnet 1 is required to support up to 100 interfaces…

Q: hink about a program that continuously delivers data (for example, the sender generates an N-bit…

A: Answer is in next step.

Q: ⦁ You are designing a connection mechanism between two programs, sending packets of data over the…

A: Given two channel capacity: capacity of the first channel: 3201 KB capacity of the Second channel:…

Q: Given the following topology of a network, the router Node 3 connects the two subnets together:…

A: (i) Default Policy: ACCEPT In this scenario, with a default ACCEPT policy on the firewall of Node 3,…

Q: An ISP has the following block of addresses 132.204.192/20. The manager of this ISP hired you to…

A: The answer is

Q: Suppose the following TCP conversation connection establishment is already complete. Fill in the…

A: TCP conversation in host A and host B to filled the seq and ack

Q: Refer the exhibit and the required number of hosts given. Subnet the address 192.168.50.0/24 for the…

A: Given: We are given a network and that network is being divided into subnets as those subnets…

Q: a) Sketch a network that contains 4 subnets (draw routers as circles with crosses inside and hosts…

A: Answer: We have written in handwritten format.

Q: A router needs to transmit an IPv4 datagram with a total size of S bytes. The link layer of the…

A: ATM Adaption Layer 5 (AAL5) is used to send variables of length packets up to 65,535 octets in size…

Q: An organization is designing their network. They will need support for a minimum of 28 network…

A: Given IP address is 192.32.64.0 Number of minimum Network segments= 28 Number of minimum hosts per…

Q: Consider a router where packets arrive at a rate of 500,000 packets/sec and the size of the packets…

A: A router is a networking device that connects multiple computer networks together and directs…

Q: Consider a router that interconnects three subnets: Subnet 1, Subnet 2, and Subnet 3. Suppose all of…

A: Subnet : The subnet is defined as dividing the IP addresses into two parts which are In the first…

Q: The address of a class B host is to be split into subnets with a 6-bit subnet number. What is the…

A: A Class B network has 16 bits reserved for the network portion and 16 bits reserved for the host…

Q: Let the size of congestion window of a TCP connection be 32 KB when a timeout occurs. The round trip…

A: Let us see the step by step answer : ANSWER : The correct answer is option 1 i.e. 1100 to 1300

Q: xplain the procedure of your subnetting scheme / Highlight the suitable prefix and the subnet mask /…

Q: Assume we have

Q: Task2: In packet switching technology the packet size is an import parameter when it con o…

A: Bundle exchanging is a technique for moving the information to an organization in type of parcels.…

Q: B. Given a block of IP addresses represented by 192.168.200.0/24, you are being asked to create one…

A: Introduction: Given IP Address: 192.168.200.0/24 /24 indicates that there are 24 network bits and 8…

Q: Node A is sending some packets to node B with one-way delay is 50 milliseconds, the bandwidth of the…

A: Introduction : Given , 2 nodes A and BPropagation delay is 50 msBandwidth is 1 Mbps Size of the…

Q: Hosts A and B are directly connected with a 1 Gbps link. There is one TCP connection between the two…

A: Given, Hosts A and B are directly connected with a 1 Gbps link. There is one TCP connection between…

Q: Use this figure as a reference, if the values are A, B, C and D (3rd octet) with the following…

A: Answer A*************** Specify routing table R1, R2, and R3, using this table! Destination…

Q: QUESTION 3 Express the following subnet masks in binary (0s and 1s) and show their CIDR prefix…

A: A. 255.255.255.124 In binary = 11111111. 11111111.11111111.10010000 B. 255.255.255.254 In binary =…

Q: LEE Chapter 4, Problem P6P Consider a datagram network using 8-bit host addresses. Suppose a router…

A: Introduction: In a datagram network using 8-bit host addresses, each host is assigned a unique…

Q: nost is to be net number s x and the ubnet is y. IS

Q: For a network address of 10.0.0.0/16, find default class, subnet mask, total number of valid hosts…

A: Given network address is: 10.0.0.0 /16 To find: 1. Default class 2. Subnet mask 3. total number of…

Q: You are a network planner tasked with developing an IP structure for the following networks. The IP…

A: In the realm of network planning, the meticulous allocation of IP addresses is a critical task that…

Q: network is shown above. The Internet Service Provider (ISP) provides the following nformation to…

A: Answer: Here, Ethernet 1 92 hosts******************** Network Subnet Mask Size Range Broadcast…

Q: eone help me with the following Computer Networking Question? I

A: Dear Student, The answer to your question is given below -

Q: SUBNET ADDRESSING Consider the router and the two attached subnets below (A and B). The number of…

A: A routеr connеcts two subnеts, A and B. Subnеt A has 175 hosts, subnеt B has 84 hosts, and both…

Q: A 3200 bit long TCP message is transmitted to the IP layer and becomes a datagram after adding a 160…

A: The packet size is 3200 bits The IP header length is 160 bits LANs datagram payload size is 1200…

Q: Network A 230 hosts Switch1 PC1 Rostert Network D Network B 900 hosts PC2 Switch2 Router2 Network C…

A: In the given network scenario, there are 2 routers, 3 switches and 3 workstations. There are 4…

Q: 6. Consider a network with some hosts. The traffic from one host to the other is provided. The…

A: Question: 1. Bytes transferred between individual hosts: Peter to Ann: 1250 bytesPeter to Mary: 910…

Q: In this problem, we consider sending real-time voice from Host A to Host B over a packet-switched…

A: Host A converts analog voice to a digital 64 kbps bit stream on the fly. Host A then groups the bits…

Q: router interconnects a subnet

A: Solution is given below:

Question

For the following problems, you are given a network address and asked to add subnet bits to produce a given number of subnets. Figure out how many subnet bits you need as well as the new prefix.

Given network address: 156.137.0.0/16

Need: at least 25 subnets

Expert Solution

Step 1

The network address is 156.137.0.0/16

Number of Subnet required=25.

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

VLSM Exercise Given the network 192.168.12.0/24, using VLSM that meets the following requirements: One subnet of 60 hosts for the Marketing VLANOne subnet of 80 hosts for the Sales VLANOne subnet of 20 hosts for the Admin VLANOne 2-host subnet to be assigned to router links
NAT translation table LAN side addr WAN side addr 135.122.200.215 10.0.1.15 10,0.1.13 address 135.122.200.215 S: 10,0,1.27 2 D: 1 D: S: S: D: S: 10,0.1.15 D: 135.122,200,215 10.०.1.22
Suppose within your web browser you click on a link to obtain a Web page. The IP address for the associated URL is not cached in your local host, so a DNS lookup is necessary to obtain the IP address. Suppose that three DNS servers are visited before your host receives the IP address from DNS. The first DNS server visited is the local DNS cache, with an RTT delay of RTT = 4 msecs. The second and third DNS servers contacted have RTTs of 45 and 24 msecs, respectively. Initially, let's suppose that the Web page associated with the link contains exactly one object, consisting of a small amount of HTML text. Suppose the RTT between the local host and the Web server containing the object is RTTHTTP = 9 msecs. Assuming zero transmission time for the HTML object, how much time elapses from when the client clicks on the link until the client receives the object? (Do not forget the TCP handshake(s).) 82 msecs O 91 msecs O 46 msecs O 67 msecs
2.
You are given the network number of 86.30.88.0/20 with the following arrangement. (12 hosts) (30 hosts) You will need to create 4 subnets: Subnet A: 30 hosts Subnet B: 55 hosts Subnet C: 12 hosts Subnet D: 65 hosts (65 hosts) Z M (55 hosts) Finally, for each subnet created, you need to calculate and show: • The first, last and broadcast address • The subnet mask • Allocate IP numbers N
Question 9 Convert the following IPv4 address into dot decimal address, and determine which type of these addresses are. a) 10000001 00001011 00001011 11101111 b) 11000001 10000011 00011011 11111111 c) 11100111 11011011 10001011 01101111 Computer network Full explain this question
• IPV6 addresses use 128 bits to represent an address which includes bits to be used for subnetting. The second half of the address (least significant 64 bits) is always used for hosts only. Therefore, there is no compromise if we subnet the network. Use the Figure below to Create five subnets using route prefix 2001:db:acad::/48 (1 Marks) Routing Prefix Subnet ID Interface ID 48 Bits 16 Bits 64 Bits
Using packet tracer, implement a network that has the following components: 1- At least five routers 2- At least 7 subnets 3- At least 12 PCs 4- At least 4 switches 5- Use RIP routing protocol To assign IP addresses of the routers and PCs, use the IP address from your ID as follows Assume your id is 118zyxw, Consider the numbers z, y, x and w as deciemal You have the subnet 118.0.0.0/24 If your ID is 1181234 then the IP is 118.0.0.0/24 Use this subnet to get at least 7 subnets.
I nedd answer point 4 and 5 please bro
Show your work for the following conversion. a) Convert the following block of IP addresses into CIDRized addresses: 11000110 10110111 10100000 00000000 to 11000110 10110111 10111111 11111111
Assume the maximum transmission unit (or MTU) of an IP packet on 100 Mbps Ethernet is set at 1500 bytes. Also, assume we are sending our file using IPv6 at the Network layer and UDP at the Transport layer. A typical IPv6 header consists of 40 bytes, a UDP header consists of 8 bytes. Answer the following three questions based on the information provided above. For all answers, enter a decimal integer value without formatting (no commas). 1. How many packets do we have to send in order to transfer a file of 24KB over 100 Mbps Ethernet? packets 2. How many bytes do we have to send at the network layer in order to transfer the above file entirely? bytes 3. How many bytes do we have to send at the data link layer in order to transfer the above file entirely? Assume that the Ethernet header is 14 bytes and the frame checksum is 4 bytes. bytes
Computer Science In Python, I am trying to make a client and server code that passes the payload with the requirements. The client has to specify the length of the data packet, up to max, specify how many times to pass the data packet, and specify the server IPv4 address. Both the client and the server need timer functions and compute the time needed to perform the number of sends both the Client and the server need to display the local and remote IPv4 addresses, total time, and bytes per second. Please help, Thanks.