For the following an ideal reheat-regenerative Rankine cycle with onereheater and two open feedwater heaters.if y= 0.17 and z=0.09 find the specificturbine workHigh-Pturhietuhinetoiler eater(10OpenOpenFWHState 13 4 5 678 9 10 11 12191.8192.2452455858.5868.5363030402890361031512540kJ/kgSelect one:a. 1492 kJ/kgb. 1602. kJ/kgO c. 1572 kJ/kgd. 1547 kJ/kg

Answered: Image /qna-images/answer/832ed7e4-9e29-40ab-8112-cd3c7c8ebe6e.jpg

Answered: For the following an ideal reheat-…

For the following an ideal reheat- regenerative Rankine cycle with one reheater and two open feedwater heaters. if y= 0.17 and z=0.09 find the specific turbine work

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg. C. Determine: a. The cycle thermal efficiency b. For the engine with the same end states, the thermal efficiency and steam rateuse the attached steam table below
turbine turbine Reheater (4 Boiler P4= P5 = Prcheat Pump Condenser The following data was given for a steam power plant operating on the ideal reheat Rankine cycle. 3-4: Inlet steam at 17.5 MPa and 600 °C 6-1: inlet steam at a pressure of 11.16 kPa at a wetness fraction of 0 1 At state 1, the specific volume is 0.00101 m/kg Find the pressure in bar at state 6 to 3 decimal places
A reheat-regenerative Rankine cycle uses steam at 8.4 MPa, 560°C and expands to 0.7 MPa. The cycle includes one steam extraction stage for regenerative feedwater heating the remainder at this point being reheated to 540°C. The open feedwater heater pressure is 2 MPa. The condenser pressure is 0.01 MPa. The reheater pressure is 0.7 MPa. Compute the energy chargeable to the cycle (heat added to the boiler + heat added to the reheater) in kJ/kg. Use the unrounded value of z when needed.
A steam power plant is operating on the ideal Rankine cycle. The boiler is maintained at 4 MPa, and the condenser at 40 kPa. The steam quality leaving the turbine is at 90%. a.) Draw the proper T-S diagram of the cycle with proper label for the points. b.) Find the temperature of the steam entering the turbine, Qa, Qr, Wt, Wp, Wnet, efficiency, and steam rate
A rankine cycle operates between a pressure limit of 6 MPa. and 50 kPa., the steam leaves the boiler at 450 C, the isentropic efficiency of the turbine is 94%, the steam mass flow rate is 20kg/sec. draw the T-S diagram assuming point 1 is at the pumpe entrance. and determine the required power to operate the pump, cycle thermal efficiency. Ans. (122 kW, 30.25%)
Regenerative Rankine steam power plant operates at boiler pressure of (12.5MPa) and the steam leaves the boiler and enters the turbine at (550°C). Some steam is exerted at pressure of (1MPA) to an open feed water heater. The still steam is continues expanding until condenser pressure of (15kPa). If the plant developed (10MW). Find the mass flow rate of steam in the cycle and the cycle efficiency.
Can the re-heater in the gas turbine power plant reduce the compression ratio Pfor a glven power rate Yes No Not related
Plz help me determine the rankine cycle Or can someone do the rankine cycle on this and how this works
A rankine cycle with water superheats to 500.546oC at 3.1546 Mpa in the boiler and the condenser operates at 100.546oC. All the components are ideal except the turbine which has an exit state measured to be saturated vapor at 100.546oC. Find the cycle efficiency with a) an ideal turbine and b) the actual turbine. Draw the schematic diagram and T-s diagram.
1.) A Steam power plant operates using the ideal Rankine Cycle where steam initially enters the turbine at 5.0 MPa and 400C then after expanding, it condenses at 7 kPa and exits as saturated liquid. Draw the TS diagram, find the thermal efficiency, and steam rate.
help on b, c, d please need answers soon