2 = ও tT Sgn i CaeElect. L Cor. SystemsClaas - Work)for the FM systen, the Carrier Signall fraquency à (25 MH)and the in formatien signal frequencqil 400 H2). if the Carrier Signalimplitude is (4v) and the frequency deviation is (te kHe);[3 write the general equation of the FM signal.2i stetch the time doma FM wave.() Fad the EM signl Power,

Given, Carrier signal frequency =fc = 25 MHzInformation signal frequecny=fm =400 HzCarrier signal…

for the FM systen, the carrier Signal fraquency i (25 MH2) and the in formation signal frequencyi( 400 H2). if the carrier Signal amplitude is (4v) snd the frequency deviation is (to kHe): [13 write the gencral equation of the FM signal. 1 Stetch the time domaa FM wave. (1) Fad the FM signal paer.

for the FM systen, the carrier Signal fraquency i (25 MH2) and the in formation signal frequencyi( 400 H2). if the carrier Signal amplitude is (4v) snd the frequency deviation is (to kHe): [13 write the gencral equation of the FM signal. 1 Stetch the time domaa FM wave. (1) Fad the FM signal paer.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In FM modulation, the magnitude and direction of the frequency shift  is proportional to the amplitude and polarity of the modulating signal.Thus, the general expression of any base-band signal frequency modulated onto a carrier
ver is in the side dulation factor m. This emphasis .8. A carrier wave of 500 watts is subjected to 100% amplitude modulation. Determine: (ii) power of modulated wave. (i) power in sidebands Solutien
Does a PCM signal have a smaller bandwidth? Why or Why not?
3. The role of mixer in the Armstrong modulator is to. a) raise the carrier frequency b) lower the carrier frequency c) to change the carrier frequency to any required value For AMDSB-SC, The carrier is suppressed using a) A mixer b) A frequency multiplier c) A balance modulator 5. In FM modulation, frequency deviation is equal to .........., if the amplitude of the modulating signal is 4 V, and the frequency sensitivity of the modulator is 30 Hz/V. a) 120 Hz b) 34 Hz c) 100 Hz 6. A voltage controlled oscillator (VCO) is an oscillator that its frequency output is varied according to any change in the ............... at its input. 4. a) Frequency b) Current c) Voltage Q1: (B) Draw A block diagram to generate the SSB using Hilbert Transform method, Write an equation for an input, and output signals?
Q2The modulating x(t)=2cos2000nt+cos4000nt is applied to AM modulator of carrier=2cos106 t. Write expression for modulation equation and Sketch the spectral of modulator output (Single Side Bandspectrum)
In an AM signal with peak amplitude of 400 volts and a peak modulating voltage of 100 volts, what is the modulation factor? a.0.33 b.0.6 c.0.5 d.0.55
Q2: An audio signal given by 15 sin(4000nt) + 20 sin(8000nt) amplitude modulated(DSB-FC) a sinusoidal carrier wave 60 sin(100,000nt) a. Derive an expression for the modulated signal. b. Find the modulation index. c. Find the spectrum of the modulated signal. d. Sketch the spectrum of the modulated signal e. Which type of demodulation method you propose to reconstruct the audio at receiver. Why?
5-If the FM modulating signal is 300 kHz, and the carrier swing is 300 kHz. Therefore, the value and the type of the modulation index are, a) 0.5 NBFM b) 0.5 WBFM c) 1 NBFM d) 1 WBFM 6- IF the modulation index of FM signal is 2, the number of significant sidebands which greater than 1% of unmodulated carrier is? (Follow the table in the last page) a) 4 sidebands b) 6 sidebands c) 8 sidebands d) 10 sidebands 7- Let the carrier given 10cos(2nd) and the message signal be 5cos(10mt). Assume the message is used to frequency modulate the carrier with ky-10, the modulation index is, a) 1 b) 5 c) 10 d) 15
B. FM modulated signal is transmitted over a noisy transmitter modulator, with the power spectral density of noise being as shown in Figure 1 (W is the information frequency with 1 KHz, Sn (f) is the power spectral density for the noise). The FM equation and transmitter is shown in figure 2. 1. Derive the FM modulated signal for narrowband modulation 2. Determine the power of the narrowband FM modulation 3. Determine the signal to noise ratio for the narrowband FM modulation s4) - A, co 2f1 + 2n, mr dr 2 mk, Baseband signal Narrowband Integrator phase modulator Frequency maltiplier FM signal N4. Crystal- contralled oscillator Figure 1 Figure 2
I need the answer as soon as possible
If the amplitude of the modulation signal voltage was given to be -4v and +4v and carrier amplitude also given to be -22v and +22v, by suitable waveform diagram determine the Am modulated output. Remember to provide all necessary wave forms in practical terms.