(c) If the carrier in part (b) has a peak-to-peak voltage of 12V and the modulating signal has a peak-to-peak voltage of 4V, determine the modulation index, the maximum and minimum voltages of the resultant Amplitude Modulated waveform and the peak amplitude of the upper and lower sidebands. Hence, determine the modulating signal voltage that would result in 100% modulation.

(c) If the carrier in part (b) has a peak-to-peak voltage of 12V and the modulating signal has a peak-to-peak voltage of 4V, determine the modulation index, the maximum and minimum voltages of the resultant Amplitude Modulated waveform and the peak amplitude of the upper and lower sidebands. Hence, determine the modulating signal voltage that would result in 100% modulation.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

IX. A carrier signal is amplitude modulated by a sinewave. The resulting AM waveform is shown below. a) b) c) d) 5.5V- 2V What is the percentage of modulation? What is the amplitude of the carrier signal? To achieve 75 percent modulation, what amplitude of the modulating signal is needed? Calculate the effective voltage of the AM signal
Does a PCM signal have a smaller bandwidth? Why or Why not?
A carrier with an amplitude of 3 V is modu- lated using 8-PSK modulation. If the noise on the modulated signal has an rms value of 0.1 V, what is the EVM of the modulated signal? [Par- allels Example 2.10]
Derive a relationship between the time constant RC, and modulation index.
Discuss the differences between noise channel and noiseless channel including the formula for each?
Q2The modulating x(t)=2cos2000nt+cos4000nt is applied to AM modulator of carrier=2cos106 t. Write expression for modulation equation and Sketch the spectral of modulator output (Single Side Bandspectrum)
Give the formula for modulation index and explain its terms.
q)what the advantages of using correlation measurements to improve signal detection?
In an AM signal with peak amplitude of 400 volts and a peak modulating voltage of 100 volts, what is the modulation factor? a.0.33 b.0.6 c.0.5 d.0.55
7. Why does PTM require a higher sampling frequency than PAM? a. The amplitude of PTM signals is constant. b. There are more sidebands in the first replica of a PTM c. Signal than in a PAM signal. d. A sample/hold circuit requires a higher sampling frequency. e. There are fewer sidebands in the first replica of a PTM signal f. Than in a PAM signal.
If the amplitude of the modulation signal voltage was given to be -4v and +4v and carrier amplitude also given to be -22v and +22v, by suitable waveform diagram determine the Am modulated output. Remember to provide all necessary wave forms in practical terms.
P4/ Calculate the approximate bandwidth (in Hz) for the modulated signal of an FM modulator whose message signal, m (t), is a 4 V and 20 Hz test tone. The deviation constant of Modulator frequency is 25 Hz/V.