For the element and state of stress shown: a) Draw Mohr's circle. b) Determine the principle stresses oi & 02 c) Determine the maximum in-plane shear stress Tmax d) Specify the orientation of the element in each case (0, and 0,).

Q: where is the shear force and normal force

A: This is follow up question of 3 hinged parabolic arch ###  So calculation of Shear Force and Normal…

Q: A solid circular bar is fixed at point A. The bar is subjected to transverse load V = 185 N and…

A: Given data:- The given force, V=185 N The given torqueT=2.9 N-m The length L=1.5 m The given…

Q: Consider a certain critical point in a stress element. On a vertical plane, the compressive stress…

A: Given Normal stress on the horizontal plane σx=0. Compressive stress is σy=115 Mpa. Shear stress is…

Q: Given an element with stresses as indicated in figure below, find the following: a) The maximum and…

A: Find:a) The maximum and minimum principal stressesb) The maximum shear stress, and the average…

Q: a) The maximum and minimum principal stresses b) The maximum shear stress, and the average normal…

A: ###Determination of given parts question of a stress system ### Principle stresses ###

Q: The strain components for a point in a body subjected to plane strain are ɛ, = -760 µe, ɛ, = -1000µe…

A:

Q: Draw the Mohr’s Circle. B. Determine the principle stresses and draw the corresponding stress…

A:

Q: Determine whether the following stress functions satisfy the conditions of compatibility for a…

A:

Q: The state of stress at a point in a member is shown on the element in Figure (1). Determine the…

A:

Q: PROBLEM 10-n GIVEN: THE STATE OF STRAIN AT THE POINT ON THE PIN LEAF HAS COMPONENTS OF = 200(106), y…

A: εx=200×10-6 εy=180×10-6 γxy=-300×10-6 θ=-30o counter clock wise

Q: 3. The plane stress is shown on the element. Use Mohr's circle. 1) Determine the principal stresses…

A:

Q: The strain components for a point in a body subjected to plane strain are &x= -1090 μe, &y=-200μe…

A: Given Data: εx=-1090 μεεy=-200 μεγxy=-724 μradIt is asked to calculate:1. Principal strains2.…

Q: 1. The plate below is attached to the vertical surface AB. Its top and bottom surfaces slide…

A:

Q: 5. The state of stress at a point in a member is shown on the element. Determine the stress…

A:

Q: Q-2-dimensional fluid elements is subjected to hydrostatic pressure 20 MPa. The maximum shear stress…

A: 2-dimensional fluid elements- Hydrostatic pressure P=20 MPa, Maximum shear stress=?

Q: 2xy tan20p 2 Principal stress: 01,2 = ) + Txy² (Ox-Gy)/2 -(0x-0y)/2 Ox+0y + Txy 2 tan20, σανg 2…

A: Given: σx=42 MPaσy=-57 MPaτxy=28 MPa

Q: 50 MPa 35 MPa B 30° 90 MPa The state of stress at a point in a member is shown on the element. You…

A:

Solid Mechanics

Engineering mechanics is a branch of science that deals with forces causing bulk motion in bodies and the effect that these forces cause on the bodies. Engineering mechanics does not deal with the internal changes that occur on account of these external forces. The internal effects in a body or a material under the action of external forces are studied in a new branch of science called solid mechanics, the strength of materials, or the mechanical behavior of engineering materials.