For the deformed plate, determine the normal strain of diagonal PR. Answer: με

Q: In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to…

A: For the given beam,

Q: Two polymer bars are connected to a rigid plate at B, as shown. Bar (1) has a cross-sectional area…

A: Given: The cross-sectional area of bar 1 is 1.52 in2. The elastic modulus of bar 1 is 2000 ksi. The…

Q: A thin rectangular plate ABCD is deformed into a parallelogram as shown in the figure below. The…

A: Shear strain is measured as a change in angle between lines that were originally perpendicular.

Q: Point A in a beam is deformed such that the strain components are ɛx = -1380 µɛ, ɛy = -880 µɛ, Ez =…

A:

Q: a steel plate, whose length (along the y-direction) is very large compared to its width (along the…

A:

Q: In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to…

A: Step 1 To Find stress at top fiber. Given data :- Gage length L = 210 mm Increase in length of AB =…

Q: The rectangular plate is deformed into the shape shown by the dashed lines. Determine the average…

A: The normal strain represents the elongation or deformation of the body that is undergone to some of…

Q: A square plate of side 300 mm is subjected to pure shear of intensity 100 MPa as shown in figure.…

A:

Q: In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to…

A:

Q: A high-strength bolt that passes through a steel plate is subjected to a tension force of P as shown…

A: (A) Tbolt=105m, D=21mm Calculate shear area of bolt head as; A=πDa=3.14×17×9A=480.42mm2 Calculate…

Q: A small T-section is used in inverted positions as a beam and is shown in figure over a span of 400…

A:

Q: 3. The picture shows a triangular element, area AB is free surface, angle B=30°, request Stress…

A: Given : Required : Normal Stress component along x direction and shear stress in X-Y plane

Q: In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to…

A:

Q: The state of stress at a given point in a material component is = 120 MPa ; Oy ox = -80 MPa and t =…

A:

Q: In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to…

A:

Q: An acetal polymer block is fixed to the rigid plates at its top and bottom surfaces. If the top…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.