For the circuit shown in figure 4, write out all equations and units in full. Assume that the voltage source V is equal to 200 V. 4.1) calculate the current in in ampere. 4.2) calculate the current iz in ampere. 4.3) calculate the current is in ampere. 4.4) calculate the current ix in ampere. 4.5) calculate the voltage in volts over the 4 A current source. Assume that the current is is equal to 4 A. 4.6) calculate the power in watt delivered by the 4 A current source. 4 A iz 4 N + 6Ωξ 30 ix V 2Ω 5 Ω Figure 4

For the circuit shown in figure 4, write out all equations and units in full. Assume that the voltage source V is equal to 200 V. 4.1) calculate the current in in ampere. 4.2) calculate the current iz in ampere. 4.3) calculate the current is in ampere. 4.4) calculate the current ix in ampere. 4.5) calculate the voltage in volts over the 4 A current source. Assume that the current is is equal to 4 A. 4.6) calculate the power in watt delivered by the 4 A current source. 4 A iz 4 N + 6Ωξ 30 ix V 2Ω 5 Ω Figure 4

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

This multiple choice Questions from MEASUREMENTS INSTRUMENTATION course.
A resistance of 10 ohms and C=0.1F is connected in series with a 12V battery. Find the charge at any time and the charge current 0.4 seconds after switch is closed.
When two identical elements of a kettle are connected in series to a 240V supply, Power developed is 400W. Find the resistance of either elements and the power developed when the elements are connected in parallel to the supply.
Which of the following statements is true ? OA. Power is additive in series and parallel circuits. O B. A battery is a current source. OC. In a closed circuit, current leaves the positive terminal of a battery, and is used up by the time it reaches the negative terminal. O D. Current only flows through the path of least resistance.
Q1) For the circuits shown in figure below, obtain the equivalent resistance between terminals. 12 ka ww- ww 12kQ www
voltage across R has to be measured with a voltmeter. What percentage error is expected in measuring the voltage if R₁=R₂=R3=R₂=R-100 Q for meter resistance of 1500 Q and 15000 Q. Also calculate the percentage error in measuring the current through R, if the ammeter resistance is 15 and 1.5 Q. Assume Eo, lo as true value and Em, Im as measured value. 10: F 20 20 I' R₁ R₂ R3 ARA A Rg J B 1500022 ģiseen 15000
Suppose a 10.0 ohm resistor is connected to an emf source to make a closed circuit. If the source has emf = 15.0 V with an internal resistance r = 0.5 ohms, which of the following correctly compares the voltage drop across the emf source and the attached resistor? O a. Voltage drop across emf source is directly proportional to the external resistor O b. Voltage drop across emf source is greater than external resistor O c. Voltage drop across emf source is less than external resistor O d. Voltage drop is the same for the emf source and the external resistor O e. None of the above
5. Consider the resistor network connecting points A and B in the figure be- low. What is the equivalent resistance between points A and B? If the potential difference between A and B is 12 volts, what is the current in the 4 2 resistor? What is the rate at which heat is produced in the 42 resistor? 1 12n
answer it theortical as it asked
5) a) An AA sized alkaline-manganese battery has a Thévenin voltage of 1.5V and an internal resistance of 0.40. What is the largest current that can be drawn from it if the terminal voltage is not to drop below 1V? b)How much power can the battery in part a deliver to a load of resistance R? What value of resistance R gives the largest power delivered to the load? What is that power?
1) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b) Terminal voltage for each branch (state whether each battery is charging or discharging). R1 26 B1 14V ++ R2 29 B2 21V R3 28 Note: All resistor values are in Ohms
The load across a 50.0-V battery consists of a series combination of two lamps with resistances of 125 ohms and 225 ohms. a. Find the total resistance of the circuit. b. Find the current in the circuit. c. Find the potential difference across the 125- ohm lamp.