For the beam shown below, determine the vertical deflection at point B by using the virtual work method. El is constant. -5 ft. A -5 ft- 12 k Į -5 ft B 70 k-ft -5 ft- Fig. 2

Q: Use the virtual work method to de termine the deflection at point C of the beam shown.

A: Given Data:Total span L=9mE=constant=70GpaI=500×106mm4Concentrated load = 100kNMoment = 300kN-m…

Q: HW 2: Determine the deflection at point C of the beam shown in Fig. below by the virtual work…

A: Given :

Q: raw the shear and bending moment diagram and determine the slope and de the beam shown by the direct…

A:

Q: 6. Using moment area method, determine the position and magnitude of maximum deflection of beam…

A:

Q: 10 Kips/ft A B 6' 6' 6' –

A:

Q: Use the moment-area method to determine the slopes and deflections at point  C of the beam shown.

A: Use the moment-area method to determine the slopes and deflections at point  C of the beam shown.

Q: 1. Use the virtual work method to determine the vertical deflection at joint C of the truss shown.…

A:

Q: Calculate the slope and deflection at the free end of the cantilever beam shown in figure using…

A: Apply standard results for each case

Q: Use the principle of virtual work to determine the rotation at Support B. (The positive direction of…

A:

Q: Part 2: for the frame shown below, P=20 kN and a=2 m, Assume I=20000 in and E=30,000 ksi for all…

A: Given:P = 20 kNa = 2mI = 20000 in4E = 30000 ksiRequired:Vertical deflection of E

Beams and Frames

A beam is a horizontal structure or a member which is always subjected to transverse shear loads.