For the beam shown below, determine the maximum shear (in kN, magnitude only) at point C due to a concentrated live load of 129 kN, a uniformly distributed live load of 58 kN/m, and a uniformly distributed dead load of 24 kN/m. Use the concept of influence lines. Point C is midway between supports B and D. Use a = 3 meters. ROUND OFF TO TWO DECIMAL PLACES. А E 4a 2a

For the beam shown below, determine the maximum shear (in kN, magnitude only) at point C due to a concentrated live load of 129 kN, a uniformly distributed live load of 58 kN/m, and a uniformly distributed dead load of 24 kN/m. Use the concept of influence lines. Point C is midway between supports B and D. Use a = 3 meters. ROUND OFF TO TWO DECIMAL PLACES. А E 4a 2a

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A C E a b From the given beam in the figure, using a uniform live load of 17 kN/m and a concentrated live load of 83 kN. Compute the maximum negative shear (kN, include sign) at C by influence lines. Use a = 3 m., b = 1 m., and c = 6 m. ROUND OFF TO TWO DECIMAL PLACES.
From the given beam in the figure, using a uniform live load of 16 kN/m and a concentrated live load of 91 kN. Compute the maximum negative shear (kN, include sign) at C by influence lines. Use a = 3 m., b = 1 m., and c = 5 m.
Determine the maximum shearing stress on the beam in MPa.
Give me the solutions of this. Identity the maximum shear and maximum moment. Answers: Vmax = 28.98 kN, Mmax = -85.25 kN-m
Application of Equilibrium Solve for the value of unknown variables Given : P1 = 10KN W1 = 5 KN/m P2 = 6 KN W2 = 10 KN/m θ= 58° a.Unknowns: RAy , RBy , RBx , MB b. compute the internal shear 1.35 m to the right of support A
.
Determine the maximum and minimum shearing stress in the web of the wide flange section in if V = 100 kN. Also, compute the percentage of vertical shear carried only by the web of the beam. 120 mm 20 mm 20 mm 160 mm 20 mm
SITUATION #2: Analyze the given structure. Draw shear and moment diagram. A -7 m 15 kN/m B El constant -7 m C
15. Provide a detailed step by step solution.
a= 4.9m b=36.3 kN/m c= 21.8 kN d= 28.1 kN/m Complete solution need ASAP. THANK YOU.
Draw the shear and moment diagram. w = 50kn/m
Apply method of superposition