For JFET, if Ipss = 15 mA. VGS (off)= - 7 V, and gm. = 4 mS or mA/V. Determine the transconductance (g) for VGS = -4 V, and find I, at this point.

Q: Determine Qcin a purely capacitive circuit where C-1000 uF, V– 120 V, and f- 60 Hz. -5.43 KVAR -120…

A: Given, In a purely capacitive circuit C=1000 μFV=120 Vf=60 Hz

Q: Find the Vout/Vin (V₁&V₂) equations and transfer functions of the circuit v/₂0 į į₂ R₁ R₂ Rf lout…

A: We need to find out the Vo for given circuit .

Q: Determine if the following circuit is a low-pass, bandpass, or high-pass circuit. Explain your…

A:

Q: M₁ Vino M Rs VDD M₂ o Vout • Vo

A:

Q: 4. For the given circuit, what is the voltage across R at resonance?

A:

Q: Vi C1 RB RC Q1 NPN RE1 RE2 C2 -Vcc CE RL -Vo

A:

Q: Since Vcc 20 V, RS = 6.1 k2, RB = 380 kQ, RC = 1.2 kn, RE = 22 kO, RL = 848 N and B = 90 in the…

A: Answer for the question is

Q: ı just need the fınal answer Since Vcc = 20 V, RS = 3 kΩ, RB = 380 kΩ, RC = 1.2 kΩ, RE = 2.2 kΩ, RL…

A: consider the given question;

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A:

Q: Derive the equation for the output voltage VOUT

A: In this question We need to determine the output voltage Vo  as shown the circuit.  We are solving…

Q: S1OCK R D, Vo V V81 V82

A:

Q: Since Vcc = 25 V, Vi = 31 mV, RB = 470 kΩ, RC = 3.2 kΩ, RE1 = 470 Ω, RE2 = 1.2 kΩ, RL = 40.5 kΩ and…

A:

Q: tion Vo(s)/Vi(s) of the

A:

Q: The circuit below has the following parameters:ß =120 , r, = 300 k2 ,r, = 502 ,C, =1pF,C, =1.924PF…

A: The cutoff frequency is a critical property of any filtering circuit, such as RC circuits. The…

Q: 1. Find the values of VR, IL, IR, L, & ZT. + VR - 35 ohms IR 10V 12V/60HZ IL

A: Network analysis problem. Look below for the solution...

Q: Q: Find a value of Vo within the specified period t [0.5 , 0.75], V [0,0.5]

A: The given value Time t[0.5, 0.75] voltage V[0, 0.5] Average voltage Vo  ?

Q: with frequency 100 Hz. It is sampled by an A/D converter, and the following two sequential values…

A:

Q: 3.) A power supply circuit is shown below. For the diodes, assume Vy = 0.7V. Sketch the output…

A:

Q: The upper cutoff frequency of an amplifier is 32 kHz. The output at that frequency is 6.71 V p-p.…

A: Option A  9.49 Vpp is the correct answer Find the magnitude ratio at given frequency and calculate…

Q: 12V 76V 024 V DO NOT ASSUME Ihat lele UA mA Re- Re- O Re Vg- v Vac Vce V. *PAY ATTENTION TO THE…

A:

Q: In the series RC circuit discussed before, R=47 ohm and C=0.02 mF. If the circuit is connected…

A: For a series RC circuit, the time constant is given as It is to be noted that the value of the time…

Q: The value of input frequency is required to cause again (Vo/Vs) equal to 0.3. The value is: 2 k2 60…

A: Given circuit,

Q: C, 0.1uF c, 0.1µF RI 4.7 kf. 6.8 kfl 4.7 kM 6.8 kN 0.1 µF R 1.0 kf 0.1 pF Ry 6.8 k 6.8 kf R 5.6 kn

A: The figure shows two sallen key filters cascaded together or called as fourth order sallen key…

Q: Low Frequency Response: Compute for the following. e. Fcl(output) 9V 2.3 ΚΩ 330 ΚΩ 1uF HH 1.6 ΚΩ 1uF…

A: BJT: It is three terminal semiconductor device that is used as a switch and amplifying the gain of…

Q: Since Vcc = 25 V, Vi = 36 mV, RB = 470 kΩ, RC = 3.1 kΩ, RE1 = 470 Ω, RE2 = 1.2 kΩ, RL = 56.2 kΩ and…

A:

Q: Question: A 1-phase full bridge inverter can operate in load commutation mode in case load consists…

A: A single phase bridge inverter can operate in load commutation mode in case load consists of  1.…

Q: What is the impedance equivalent of  Series LC 22. What is the impedance equivalent of a series…

A:

Q: 0.1 For the circuit shown, calculate the A, and the C2 that required to obtain 1.77KHZ lower…

A:

Q: Two signals m, (t) = m2(t) = cos(2n × 15t) are both to be transmitted simultaneously over a channel…

A:

Q: Amplifier's Frequency Response Vcc=20V R1 = 40 kohm R2 = 10 kohm Rc = 4 kohm RE=2 kohm Rs = 1 kohm…

A: In this question We need to choose the correct option Lower cut off frequency of the given circuit.…

Q: For the following crcwt , the in-voltage_is l00 V perr 652 Find: OEOA The max voltage (Justify ) 4Mf…

A: "According to the Company's policy we will solve only the first three subparts of the question".…

Q: in Series Circuit where R=102, L = 1H C = 4MF Frs (~-~-) HZ , 2r= бо * In a free Sourc Rc Circuit…

A:

Q: Question 3 feelboak anity function This is Cl0sed- loop 3ystem cwith which is has open -lbop…

A: Open loop transfer function is given G= 10/s(s+1)(s+5)  Draw the bode plot i.e magnitude plot and…

Q: An RC-LPF circuit has R = (16) kΩ and C = (10)-μF. Find (a) the radian cut-off frequency (b) The…

A:

Q: A received signal power of -90DB is equal to O - 120dBm O None O -60dBm O - 100dBm

A:

Q: R=1K Vz-3V D: Vo

A: Given data is-         Supplied voltage V=8 v    Zener diode voltage Vz=3 v   silicon diode voltage…

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.