For determining the dryness fraction of a sample of steam at 14 bars, it was passed through a throttling calorimeter attached to the steam main. The pressure and temperature after the throttling process were recorded to be 120KPA and 248°F respectively. Calculate the dryness fraction of steam before passing through the throttling unit. Take cps=2.1KJ/kg for superheated steam.

For determining the dryness fraction of a sample of steam at 14 bars, it was passed through a throttling calorimeter attached to the steam main. The pressure and temperature after the throttling process were recorded to be 120KPA and 248°F respectively. Calculate the dryness fraction of steam before passing through the throttling unit. Take cps=2.1KJ/kg for superheated steam.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A and B containers (fixed volume) are connected together by a valve. Tank A contains 400 kPa and 0.3 m3 refrigerant 134a at 60% dryness. Tank B contains 0.5 m3 of refrigerant 134a at 240 kPa pressure and 100 oC temperature. Then the valve is opened and the system reaches 280 kPa equilibrium pressure. Calculate the final temperature.
calculate the amount of heat required to generate 3000 kg of dry saturated steam at a pressure of 8 bar from water available at 30°C.
1. Combustion gases enter the nozzle of a jet engine at 3.8 bar and 820°C. The nozzle is well insulated and the gases expand down to an exit pressure of 1.1 bar. Determine the temperature and the velocity of the gases at exit from the nozzle assuming the velocity at inlet is negligible. For the combustion gases take c, = 1.15 KJ/Kg. K and the ratio of specific heats = 1.32
An ideal gas at 27°C expands isothermally and reversibly from 10 to 1 bar against a pressurethat is gradually reduced.
Determine the amount of work required to compressed 1.5 kg of air at a pressure of 7 barg. The isentropic index is 1.2 and the air intake is at 1 bar, 200C & RH =65% v) The discharged air is passed through an R134a refrigerant dryer, the temperature of air coming out the dryer is 400C. The air then settles inside a reservoir at a temperature of 25 0C. Determine: The humidity variation throughout the production of compressed air The amount of condensate formed at each stage of the process by using The humidity definition
السؤال الثالث The thermodynamic properties of refrigerant R22 mixture of liquid and vapor leaving the expansion device and entering the evaporator are: pressure of 498 KPa, temperature of 0 °C, fraction dryness (x) of 0.238, saturated liquid enthalpy of 200 kJ/kg, and saturated vapour enthalpy of 405 kJ/kg. The pressure of this refrigerant at the entrance of the condenser is measured to be 19.3 bar After the subcooling process, the enthalpy in (kJ/kg) and the pressure in (MPa) of this refrigerant have been measured and were found to be 199 47 kJ/kg and 2.3 MPa. 239. 68 kJ/kg and 1.96 MPAO 248.79 kU/kg and 1.93 MPa 110 52 kJ/kg and 3.1 MPa 1:29 PM 91°F Sunny 5/14/2022
200 m3/min is passed through the adiabatic humidifier. The condition of the air at inlet is 40C db and 15% RH and the outlet condition is 25C db and 20C wb. Find the amount of the water vapor added to the air per minute.
2) In a well-insulated fixed-volume closed vessel, there is initially 5 kg of saturated liquid-vapour mixture water at 100 kPa pressure. In this state, one quarter of the total mass is in the vapor phase. Then, the electric heater in the container operates and a current of 8 A flows through the heater plugged into a 110 V outlet. How long will it take to evaporate all the liquid in the container? Plot the phase change in the T-v diagram showing the saturation curves.
Saturated steam at 10 bar pressure is supplied to increase the temperature of the feed natural gas from its inlet temperature of 30°C to within 15°C of the steam outlet temperature. All steam properties can be verified in the steam table, attached. Evaluate the mass flow rate of the steam supplied, if about 20% of the steam is still uncondensed at the exit. The relevant properties of Natural gas (NG) are as follows: NG Flow Rate = 1500 kMol/hour Average specific heat Capacity of NG = 40 kl/kMol.°C.
Moist air at 35 °C dry-bulb temperature and 50% relative humidity enters a cooling coil at 300 m³/min and is processed to final saturation condition at 12 °C. Draw the process on the psychometric chart and find the required cooling load in kW. Assume the enthalpy of the removed water is hw = 42kJ / kg
Calculate the partial vapor pressure in kPa of air-vapor mixture when the following conditions prevail: t = 20°C, W = 0.0015 kgv/kgda, and pt = 0.70 bar.