fo = Calculate the resonance frequency fo of the circuit when the resistance R1 is terminated in the circuit. NOTE: Showthe complete solution and attach to the file. Hz 8. IL - А 10. Still at resonant state based on item 8, measure the currents IL, IC, component IC - А ILsine, and the total current I of the circuit. Also determine the value of ILsin0 - А impedance Z by taking the ratio of V and I in item 10. I- А Z- Ω

Q: c) Fig. B2c shows a IGBT with a freewheeling diode use to protect the transistor in a motor control.…

A: According to the question an IGBT with a freewheeling diode is used to protect the transistor in a…

Q: In a balanced three - phase wye -delta system, the source has an abc - phase sequence and…

A:

Q: what was the calculation done to get d? Confused on how this was rearranged.

A:

Q: Holes are the major charge carriers in Intrinsic semiconductors n-type semiconductors p-type…

A: Intrinsic semiconductor also known as pure semiconductor as the inpurities are very negligible in it…

Q: Please answer in typing format

A: The circuit consists of two NOT gates connected in a loop. Each NOT gate inverts its input signal.…

Q: 4) Disadvantages of SMART GRIDs. 5) Recent Government policies in Canada in regard to Smart Grids

A: NOTE: As per the guidelines will be solving only question 4 and 5 as asked. Please repost for…

Q: Make a circuit that controls two LED's with a single switch; plus one of the LED's is controlled by…

A: Since you have posted multiple questions, according to guidelines, we will solve only the first…

Q: 4) Calculate the value of the resistance Rled in Circuit #1, to ensure that a GREEN LED will have a…

A:

Q: 3kN R2 6 k

A: "Since you have posted a multiple question we will solve first question for you .To get remaining…

Q: An abc - phase sequence three - phase balanced wye - connected source supplies a balanced delta…

A:

Q: What are the quotient and remainder when - 35 divided by 4 ? -7 and -7 -8 and -3 O. -9 and 1 O. 9…

A: According to question we have to find the value of quotient and reminder.

Q: In reality, wires do not have zero resistance. Where does the resistance of wires come from, and…

A: We need to answer the following two questions: In reality, wires do not have zero resistance. Where…

Q: Which of the following-combinations cannot be combined into K-map groups?   A. corners in the same…

A:

Q: 4. current overloads. " and are used to protect circuits against

A: In this question, we need to fill the blanks. What are the name of devices which are used to protect…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.