Flow rate was monitored for a week, and the following values were recorded as gal/min: 10.1, 12.2, 9.7, 8.8, 11.4, 12.9, 10.2, 10.5, 9.8, 11.5, 10.3, 9.3, 7.7, 10.2, 10.0, and 11.3. Find the mean and the standard deviation for these data.

Q: A laboratory model of a river is built to a geometric scale of 1:00. The fluid used in the model is…

A: Mass density of model fluid=900 kg/m3Geometric scale 1 : 100Highest flood in river = 10,000 m3/sThe…

Q: Answer Four Questions 1. The discharge measured in a stream at various stage are given below. Plot…

A: To estimate the discharge at a stage of 9 meters, we will plot the given stage-discharge data and…

Q: Given the inflow and outflow discharges: Time (h) Inflow (m³/s) Outflow (m³/s) 1 93 85 3 208 114 442…

A:

Q: estimate the size of a container to be used

A: persons = 192 The average occupancy rate for each living unit is 3.1 personsNeed to findthe size of…

Q: Sparky created a pumping system between Hydaway Lake and a holding pond on the Snowflex property.…

A:

Q: 3 m P Lower reservoir 100 m 1 m Upper reservoir 10 m

A:

Q: The 2-hr unit hydrograph is given in the table. Determine the 6-hr unit hydrograph. Use the given…

A: given data  time 2hr unit hydrograph  0 0 1 15 2 21 3 18 4 6 5 0

Q: The annual daily mean discharge data for USGS 08057000 (Trinity Rv at Dallas, TX) is shown in the…

A:

Q: You run an experiment to estimate the water flow rate of the drip irrigation system in the Elon High…

A: Given data, Diameter = 11.2 cm Time t = 2 hrs.

Q: A rapid sand filter is washed once every 24 hours. Determine the time of washing X if the quantity…

A:

Q: Problem 1 メ=7 A scaled model of a proposed dam is used to predict the flow conditions in the…

A: Given data-

Q: Using the graphical (Rippl) method, determine the capacity of a storage reservoir to maintain a…

A: Demand= 40 m3/sfind the reservior capacity

Q: What is the flow rate in gallons per minute for a pipe that has a roughness coefficient of 130, a…

A:

Q: Assuming the data follows a Normal distribution, compute and plot the probability mass function…

A:

Q: 6-13. A 50-year annual series of peak river discharges with a mean of 2000 m/s and standard…

A: Given: Mean Discharge x¯= 2000 m3/ sec Standard Deviation (σn-1)= 500 m3/sec Recurrence Period T =…

Q: The flow into a reservoir over a one hour period is shown in the following table. tt (minutes) 0…

A: The given data shows the flow into a reservoir within one hour period. The interval period is 10…

Q: Assuming the data follows a Normal distribution, what is the probability that the discharge is…

A:

Q: What volume equalization basin is required to even outflow variations in the following data? Assume…

A: Given: Flow values and time To find: Volume of equalization basin

Q: 1. Given below is a 2hour unit hydrograph. Derive 8 hr unit hydrograph by S curve method Time 0 2 8…

A: The ordinates of the 2 hr unit hydrograph is given,First we need to get S-curve ordinates then from…

Q: The annual daily mean discharge data for USGS 08057000 (Trinity Rv at Dallas, TX) is shown in the…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.