Find the missing load (F) in the figure given the resultant of these three parallel loads is 30KN acting up at 10 meters to the right of A. Compute the magnitude and position of the missing load. 40 KN 60 ΚN 2 mtrs 11 mtrs

Q: What is a plumbing tape?

A: Let us analyse the question ( Plumbing tape ) in step 2.

Q: List several locations where flashing is required?

A: flashing  - flashing use as a obstacle for water penetration. it is thin impervious layer on the…

Q: Design Calculation of stair climbing trolly

A: In day today life we may have to carry so many goods and objects of various quantities through…

Q: Select appropriate air heating and cooling systems?

A: Selection of Air Heating and Cooling System:  There are six factors to select the appropriate air…

Q: what is piping system?

A:

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: How to do a evacuation Floor plan like an example

A: An evacutation plan is one of the most common and important plannings in any project. They are…

Q: Define tropopause.

A: The earth's atmosphere can be classified into four layers, Troposphere Stratosphere Mesosphere…

Q: Define emission factor?

A: Emission Factor An emission factor is a representative value that attempts to relate the quantity of…

Q: Define Bucket augers

A: Unconsolidated Soil: If the soil has not reached the equilibrium under the applied overburden loads,…

Q: Illustrate a simple drawing plan of pipeline

A: Simple drawing plan of pipeline: The piping plan or general arrangement drawings show all major…

Q: Define Air-handling equipment.

A: Air-handling equipment is defined as the equipment that is used to regulate the temperature of the…

Q: of CAG. 2) D= 9M.

A: Here, B & d are the actual dimension of rectangular region which is inside the circle. After…

Q: What escalator installation configurations are generally used?

A: Answer Introduction An escalator is a device that is used for transporting people from one floor to…

Q: Q2) From figure below compute:- a) CBA area. b) Level difference between A and B. staff in A staff…

A:

Q: What are canopy restrictions?

A: Canopy:

Q: delermine wether G) is analytic ornot.

A:

Q: How does a plumbing contractor know what slope is required on sanitary piping installations?

A: The slope changes as the temperature changes in a sanitary installation.

Q: How are concrete water tanks insulated

A: Insulation of concrete tank is required because loss of moisture can occur as a result of the…

Q: 2. Explain the difference between the TRIM default option and TRIM double enter. O Enter your answer

A: Trim default: This tool is simple to use. We need to just select the object which needs to be…

Q: y thermal bridging? thank you if you will answ

A: A thermal bridge, also known as a cold bridge, is a section of a building with much higher heat…

Q: 1. Locate the centroid (£, 9) of the shaded area. 6 in. 3 in. 6 in. 6 in.

A: We are supposed to answer the only the first question, Kindly understand and post other question…

Q: The floor area measured at floor level is termed as build-up area Select one: O True O False

A: Given data:- the floor area measured at floor level is termed as build up area. a. True b.False

Q: A restroom should be located within 400 feet of every permanent workstation

A: Maximum distance is 400 feets ... Maximum of above or below 1 floor in case of building..

Q: disscuss the following items in relation to plumbing system: a. supply pipe b. fixture c.…

A: Supply Pipe: A supply pipe is used to convey water or sewage from the source of generation to the…

Q: What are the common types of lighting systems?

A: There are different types of lighting systems Incandescent light bulbs Fluorescent lamps. High…

Q: Flowchart of how to estimate WIND LOADS

A:

Q: Which dimensions should be taken into account while designing a cyclone seperator?

A: The dimensions or parameters should be taken into account while designing a cyclone separator are…

Q: quality management plan of Lrt eglinton midtown crossover construction project. 500 words

A: here is your answer below ;

Q: Describe in detail a typical layout of an escalator systems

A:

Q: Please solve both question and detail solution and not Copypaste otherwise down vote

A: True  Hvac System design must be prepared by a licensed professional engineer beacause they used…

Q: hat is volume anaylsis system?

A: Civil engineering is mainly concerned with the planning and detailing of the structure. So for the…

Q: Describe with characteristics details for one of the plumbing devices in buildings

A: The various sanitary fittings provided in buildings, such as wash basins, bath tubs or bathrooms,…

Q: Describe about the drainage filter.

A: The drainage filter can be defined as it is made up of granular material either natural or processed…

Q: From this plan view,which one is the length and which one is the width and please justify your…

A: The length shows the longer side of the figure, while the width shows how broad or wide it is.…

Q: Drainaige system

A: ● Solution:-  Flow of water through a well-defined channel is known as drainage we can say that a…

Q: 100 KN

A:

Q: 2. In your own words, describe how the buddy works in the event of the release of a hazard

A: Hi! Thank you for the question As per the honour code, We’ll answer one question since the exact one…

Q: what is cirque water pumps

A: A cirque water pump, also known as a circulating pump, is a type of closed-circuit pump that…

Q: What are the requirements for the Plumbing Design for water supply?

A: Requirements for the Plumbing Design for water supply:-  Available water pressure:-The first step…