Find the largest and smallest angle changes with their directions at point A, as the unit elongations in three directions with 120◦ between them are a = 430.10-6 Ꜫb = 260.10-6 Ꜫc = 590.10-6 as shown in the figure

Q: 5. Determine ỹ, which locates the centroidal axis x' for the cross-sectional area of the T-beam, and…

A:

Q: Locate the centroid x of the cross-sectional area for the angle. Set a = 10 in ., b = 30 in.x=15.0in…

A:

Q: 2. Determine the displacement at point C of the cantilever beam. The moment of inertia of each…

A: Given data  Concentrated moment  Span length  Moment of inertia  Cantilever beam  Elastic modulus

Q: 2. Consider two forces F, and F₂, both having the same magnitude. F, makes an angle of 60° with both…

A: Given:Required: Angle between two forces

Q: Clarification: "AP" indicates the coordinates of point A

A: To determine the central axis of the system of sliding vectors, let's break down the problem step by…

Q: Determine the moments of inertia of the rectangular area about the x- and y-axes and find the polar…

A:

Q: Determine the displacement at point D of the beam in the figure. Use virtual work method only. Use E…

A:

Q: A wooden beam is loaded by a distributed load w = 6 N/mm as shown in Figure Q4(a). The cross-section…

A:

Q: Problem #1 Determine the horizontal displacement at point C of the truss shown by the method of…

A: Trusses are a structure that is widely used to carry a wide variety of loading conditions under…

Q: 9–31. Determine the displacement and slope at point C of the cantilever beam. The moment of inertia…

A:

Q: 3 in. in. 2 in. i in. 2 in. i in. Prob. 9-66

A: The location y¯ of the Centroid for a beam having the cross section area is shown. The beam is…

Q: 2. Using the conjugate beam method, determine the slope and displacement of the pin B connected to…

A:

Q: 1. Find the force in members AB, BC, BD and CD. 2. Find the absolute vertical displacement of joint…

A: Given: EA= 2000 k for members AB, BC and BD.            EA= 4000 k for member CD           alpha =…

Q: Use virtual work to find the displacement at point C

A: We will apply unit load at C.

Q: A beam 3 m long is simply supported at its ends. The beam is loaded with a downward vertical load of…

A:

MATLAB

MATLAB software is a registered trademark, multi-model programming language, and numerical computing environmental system created by MathWorks. 'MATLAB' is the short-form of "Matrix Laboratory". The MATLAB software permits the utilization of matrix operations, graphical representation of data, execution of algorithms, development of user interface, and linking programs created in other languages. Even though MATLAB is developed mainly for numerical computing, there is an optional toolbox that uses a symbolic engine known as MuPAD giving access to all the symbolic computing abilities. In addition to this, a Simulink package delivers graphical multi-domain simulation and design that is model-based for embedded and dynamic systems. MATLAB users are spread worldwide across the world and use MATLAB extensively.