find the diameter and drawdown of well witch is penetrating in unconfined aquifer with depth 12 m to discharge the water at rate 0.5 cumcs from a ground, the hydraulic conductivity is 10 m/day, the storag coefficent of medium sand soil is 20, the drawdown of two testing wells awy 330m and 510m is 2.4m and 1.2m, respectively?

find the diameter and drawdown of well witch is penetrating in unconfined aquifer with depth 12 m to discharge the water at rate 0.5 cumcs from a ground, the hydraulic conductivity is 10 m/day, the storag coefficent of medium sand soil is 20, the drawdown of two testing wells awy 330m and 510m is 2.4m and 1.2m, respectively?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 300-mm diameter test well penetrates 27 m below the Water is pumped at for 24 hrs. The observation wells 35 m and 95 m from the test well were of static liters per 69 two water table. a rate second water levels at lowered by 1.10 m and 0.50 m, respectively. a. Compute the flow rate in MLD (megaliters per day). b. Compute aquifer. c. Compute the transmissivity of the coefficient of permeability of the the aquifer. Use the q In T = 2π (h2-h1) formula
What will be the value of coefficient of permeability (k) for an unconfined aquifer 10 m thick (Piezometric height) if a well delivers 360 m³/d water? Observation well (1) is situated at 20 m from the pumping well and records a drawdown of 6 m. Observation well (2) is situated at 600 m and the drawdown is 3 m. The original water table at was recorded at 12 m.
A site consists of a homogenous dense silty sand layerof 8m thickness which is underlain by an imprevious stiff clau stratum. The initial water table was at 3m depth below the ground level. A pumping test was carrier out by pumping water at the rate of 0.7 m^3/min. Onservation wells were dug into the ground at 25m and 50m distances from the center line of the well. At steady state (i.e., when there was no change in water levels in the observation wells), the water levels in the two wells dropped by 500mm and 150mm, respectively. Determine the hydraulic conductivity of the clay sand layer.
A pumping test was carried out in confined aquifer thickness 2 m and the following measurement was recorded. Rate of pumping was 10 m^3/s; drawdown in pumping well was 2.0 m while on the observation well located at 15 m and 20 m from the centre of the pumping well were 1.6 m and 1.4 m, respectively. Determine the hydraulic conductivity of soil.
5.The diameter of a well is 300 mm and the depth of the aquifer is 20m. The radius of of circle of influence was found to be 135m. The coefficient of permeability of soil is 30 m/d. Calculate the drawdown of the well if the aquifer is a) confined, and b) unconfined. The yield required from the well in both the cases is 3000 cum/d.
A well pumping test was carried out to determine the bulk permeability of a confined aquifer. The aquifer was overlain by a clay layer 4m thick, the depth of the aquifer was 20m, and the initial piezometric level in the aquifer was 2m below ground level. After a period of pumping when steady state conditions had been reached, the following observations were made:pumped flowrate q=1.637 li/swell radius=0.1mdrawdown just outside well = 2mdrawdown in piezometer at 100m distance from well = 0.2m.Determine the bulk permeability of the aquifer in m/s . Use the format for your answer 1.111 x 10^(-4).
Estimate the Q that produced a drawdown in a 1 ft diameter well of 5 feet above the bottom of a pressurized aquifer with a 35 ft thickness and a head in a monitoring well 55 ft away 25 ft above the bottom of the aquifer in a clean course sand aquifer with K ~ 3*10^(-3) ft/sec.
A capture well is pumping at a rate of 1700 m^3 /day from a confined aquifer with a hydraulic conductivity of 425 m/day, an initial hydraulic gradient of -0.00098 and a saturated thickness of 22 m. Water is flowing from west to east. a. What is the maximum width of the capture zone in m to the nearest ones place? b. What is the distance from the well to the stagnation point in m to the nearest ones place? Consider what sign makes sense. c. True or False: The majority of the capture zone is to the west of the capture well.
Problem 3.5 A well of diameter 0.3 m is constructed to the full depth of an unconfined aquifer of thickness of 150 m. The water table is 10 m below the ground surface. A pumping test of 12 m'/hour has resulted a drawdown of 10 m. Assuming ro = 400 m; calculate the coefficient of permeability of the aquifer. If the flow rate increases to 18 m'/hour, and in the absence of any other data, what will be the best estimate for the drawdown in the well?
Water resources H.W No. 4 Q1-Falling head permeability test, given soil sample: length is 50.8 cm, area=10.17 cm?, area of stand pipe=1.3cm? , head at time zero(to)=76.2cm. head at time 10 min=30.5cm.a) Find hydraulic conductivity of the soil sample. b)what was the head difference at 5 min.
TELEGRAM Q1: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0 m below the static water table. After a long period of pumping at a rate of 1.2 m3/min, the drawdown in test holes 11m and 35 m from the pumped well is found to be 3.05 and 1.62m respective. What is the hydraulic conductivity of the aquifer? Express in meters per day. What is its transmissivity? Express in cubic meters per day per meter. What is the drawdown in the pumped well?