Find the dB gain for a whisper increasing from 10^−11 watts/cm^2 to 10^−10 watts/cm^2.

Q: Calculate damping coefficient of a viscously damped system having mass of 4 kg undergoing resonant…

A:

Q: A negative point-charge Q 10 cm direcly below a positive point-charge Q as shown in (Figure 1)…

A: Step 1:

Q: Three guy wires are used to keep an antenna pole standing in a vertical position. The pole and guy…

A: C) 62.54 deg

Q: = If you are given two sound intensities, 65 db and 68 db, what will be the sound intensity level…

A:

Q: Q.01 A vibrating SDOF system is viscously damped such that ratio of two consecutive amplitudes is…

A: Now we determine logarithmic decrement

Q: In a falling-ball viscometer, the ball attains terminal velocities of 0.01 m/s for oil A and 0.002…

A: Given data- A falling ball viscometer- Terminal velocity of oil A, (VT)A  = 0.01 m/s Terminal…

Q: A blink of a human eye takes approximately​ 300-400 milliseconds​ [ms]. Convert 311 milliseconds​…

A: Given, A blink of human eye takes approximately 300 - 400 milliseconds. One shake = 10 nanoseconds

Q: Calibration: 11.69 kg 15.47 kg 3.78 kg = 28° 1. Mass of the measure plus plate, kg (Mm+p) %3D 2.…

A: Percentage absorption of the aggregates is the absorption calculated at saturated surface dry…

Q: Solve for the Resultant (Magnitude, Direction, and Location x) for the Nonconcurrent system below.…

A: A system of non-concurrent forces is given, it is required to replace the forces with a single…

Q: the seismic waves energy affected by: Select one: a. 1 and 2 b. The displacement amount in rocks c.…

A: Answer : The seismic wave energy is affected by both 1 - The physical properties of the Earth's…

Q: A horizontal wire is stretched with a tension of 94.0 N, and the speed of transverse waves for the…

A: Given: Pavg = 0.365 W Tension F = 94 N Speed V = 406 m/s² Frequency, f = 69 Hz  Required : Amplitude…

Q: Calculate the error

A: This question has been taken from Surveying engineering and the explanation is given below:

Q: Identify what response function does the following influence lines represents; example (a. IL for…

A:

Q: Seismic waves are used to determine and examine the earth components, What type of seismic waves ?is…

A:

Q: Sample Problem : Resolve the 170 lb force of Fig. below into two components, one along AB and the…

A: Given Force vector with 170 lb magnitude Directions of AB and CD   To find Components along Ab and…

Q: A CFD model of steady two-dimensional incompressiblefl ow has printed out the values of velocity…

A: The ∅ values are lower on the left than right , ∴ , u is to the right .The ∅ values are lower on…

Q: In an undamped free vibration of single degree of freedom, the maximum velocity is 0.3 m/s and…

A: Here ,given details are Maximum velocity = 0.3m/s natural frequency= 10 rad/sec

Q: In the figure shown, I=150mm, b=70mm and wAB=1100rpm (clockwise) Solve for (a) the velocity(m/s) of…

A:

Q: hich of the following second order transient respom

A: option (a) is the correct answer. Damping in structural systems is depicted by the term called as…

Q: Select all of the statements that are true about the natural period The point at the end of the…

A: This question is related to Structure analysis from Civil Engineering. This is subject to Natural…

Q: Example 8.10 For a head of 25 cm on a 90° V-notch, what error in the measured head will produce the…

A:

Q: The sound pressure level for a jet plane on the ground with sound pressure of 3000 μ bar should be

A: Given data,Sound pressure = 3000 μbarto find the pressure level for a jet plane on the ground

Q: Transmission of sound wave can be from outside of a building to inside, or from one space to another…

A: Sound- As an audible mechanical wave, sound is defined as vibrations that move through the air or…

Q: Q.121 A vibrating system of mass 20 ka and spring with stiffness 32 N/mm is viscosly damped so that…

A:

Q: Q.33 ' A viscously damped system having resonant amplitude of 1.5 m, spring of stiffness of 1600 N/m…

A: We have to find Damping coefficient in percentage. Using given data

Q: QI: Find ApH ? 10 kN/m 5 m El constant 10 m

A:

Q: Example 8.10 For a head of 25 cm on a 90° V-notch, what error in the measured heac produce the same…

A:

Q: The natural frequency of a mass mat the end of the cantilever beam of negligible mass with usual…

A:

Q: Find the output of the following system (plot the waveforms) 1) System g(1) f(t) h(t) A h(t) +1

A: Solution: Given:- From given information:ft=ut+1-ut-1f∆ =ess-e-ss It is from property of laplace…

Q: Locate the centroid of the shaded area in the figure. Measured from the given axes. 2 m 2 m 2 m 2 m…

A:

Q: flection on Change Detection in Unmanned Aerial Vehicle Images for Progress Monitoring of Road…

A: Introduction- Presently, automated ethereal vehicles are progressively being utilized in different…

Q: 11. CURVATURE AND REPRACTION. By taking a sight across a lake 24 km wide through a pair of…

A:

Q: 4. Which among the following is not generic property of sound?

A: To find : Which is not generic property of sound.

Q: 20000 cm 10500 cm 14000 cm ELEYB (14C00 cm) 1 ELEVA(13000 ca) Eug rc (1000 cm)

A:

Q: A system curve relates the system's required head (energy) to its velocity. True False

A: A system curve related to the system's required head (energy) to its velocity is true/false?

Q: 4. Compare the deflection values for both cases given below, Which one is safer if the 'limit is…

A:

Q: 7.45 An electron beam is sent through a potential barrier 4.5 Å long. The transmission coefficient…

A: Resonance Condition: ka=nπ= n  For the third maximum (n=3):   k=3π/4.5×10−10 m≈2.094×1010 m−1 Wave…

Q: The bubble tube of a level has sensitivity of 30" per 2mm divisions. Find the error in staff reading…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.