Three guy wires are used to keep an antenna pole standing in a vertical position. The pole and guy wires are mounted on level ground. The upper ends of the guy wires are all attached at the same spot on the pole. The other ends are attached to anchors on the ground. Two guy wires, stretched at 20 m long each are inclined 60 degrees with the horizontal. The third wire, due to limited space was mounted on an anchor on the ground nearer to the pole by 1m. Determine the angle the third guy wire makes with the horizontal.

Three guy wires are used to keep an antenna pole standing in a vertical position. The pole and guy wires are mounted on level ground. The upper ends of the guy wires are all attached at the same spot on the pole. The other ends are attached to anchors on the ground. Two guy wires, stretched at 20 m long each are inclined 60 degrees with the horizontal. The third wire, due to limited space was mounted on an anchor on the ground nearer to the pole by 1m. Determine the angle the third guy wire makes with the horizontal.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2.13 The resultant of three tensions in the guy wires anchored at the top of the tower is vertical. Find the un- known but equal tensions T in the two wires. All three wires and the tower are in the same vertical plane. mom x won goalsq sr 11 JAG BESHI BRIGH AGU Figure 2.52
Observe the behaviour of the tower when left alone.
Locate the point of inflection from A
For the loading shown in Figure 5, detemine the required intensity (w) and the dimension (d) of the right support so that the resultant force and couple moment about point (A) of the system are both zero. 200 N/m 75 N/m -0.5 m- -3 m Figure 5
What advantages does the automated method have over the manual method?
solve the reactions using slope deflection method without settlements
Please input correct answer
Q2 : The antenna tower is supported by three cables. If the forces of these cables acting on the antenna are F-510 N, Fc - 640 N and Fo- 560 N determine the magnitude and coordinate direction angles of the resultant force acting at A. Fs EC 20 m 8m 12 m 18 m -16 m. Fig. Q2
I need the answer at 20 minute .
Replace the loading by an equivalent resultant force and specify its location on the beam, measured from point A.
solve the reactions using slope deflection method without settlements
1. A force of 250 kN at 25° is combined with a force of 180 kN at 100°. What is the resultant force in kN? A. 362.23 C. 356.58 B. 324.56 D. 343.79 5.343.7 15:30 0800- 2. A hanger is to support a 1340-kg object. If the ultimate tensile strength of the rod is 350 MPa and a factor of safety of 3 is to be used, what rod diameter is required? A. 10 mm C. 11 mm Tol SAT ES B. 13 mm D. 12 mm dom