Find the block shear strength of welded tension member as shown in figure. [Use Fe410 steel] 120 10 mm thick 250

Q: Regular low-alloy steel has an allowable shearing stress of approximately 20.0 ksi (Fv = 20.0 ksi).…

A: Answer  In order to check the adequacy of given beam for allowable shearing stress fv = 20 ksi we…

Q: Rigid bar ABCD is loaded and supported as shown. Bars (1) and (2) are unstressed before the load P…

A:

Q: Required information A square yellow-brass bar must not stretch more than 105 GPa and that the…

A:

Q: A threaded round steel bar is subjected to a tota axial pull of 8000 lb. If the diameter of the…

A: Take diameter of threaded portion≈unthreaded portionso,Stress=PArea

Q: A steel 4340, with tensile strength of 550 Mpa and Compressive -550 Mpa with length of 3.5 mm find…

A: Permissible maximum stress to a structural member is generally subjected, that is large enough to…

Q: The plates in the figure below are each 3 inches by 0.5 inches in cross section. If the hole in each…

A: Solution:- Given information: Cross section of plate =3×0.5 in Hole diameter, d=1316 in, and Load,…

Q: A torque T-43 kip-in. is applied at end A of the composite shaft shown. Know that the modulus of…

A:

Q: A steel rod of 30 mm diameter is used as a tie member in roof truss. It may be subjected to reversal…

A: Given-

Q: What is the approximate value of the tensile strength governed by yielding of the cross- section of…

A:

Q: A mild steel flat of width 120 mm and thickness 10 mm is bent into an arc of a circle of radius 10 m…

A: Width of mild steel flat b=120 mm,Thickness t=10 mm,Radius R=10 m,To Find-The value of the pure…