Find H(@) of a 3-point weighted adder, given by the input-output relation:k² +1y(n) = Ex(n-k). Also find the amplitude |H(@)| and the phase Z H(@).k + 2k=0

Answered: Image /qna-images/answer/73540675-9474-4d0b-947e-004cd8d7bcf8.jpg

Answered: Find H(@) of a 3-point weighted adder,…

Find H(@) of a 3-point weighted adder, given by the input-output relation: 2 +1 y(n) = x(n-k). Also find the amplitude |H(@| and the phase Z H(@). k + 2 k-0

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A resistor having a resistance of 40 ohms is connected in series with an inductor having an…

A: To find the resonant frequency of the circuit in rad/sec

Q: The tranfer function of a system is given follows 16 [s°t 8s+ 16] Considering determine applied to…

A: In this question, We need to determine the output if input is unit step signal.

Q: For the figure system 5 Σ sis + 2) I+ as Find the characteristic equation and bring it to the Evans…

A: A transfer function on any Linear time invariant system is the ratio of output to input with zero…

Q: The PSD of a WSS random process x(t) is shown in the following. a. Find the power in DC term b. Find…

Q: Write the required equation of the frequency response H(wo) of the Ideal LPF with drawing.

A: Types of Filter High pass filter Low pass filter Band stop filter/ Band Reject filter Band pass…

Q: the steps sect. 15.3, tổ design a cascaded 3-stage active bandpass filter (Fig. 15.10) with a low…

A: (1): A block diagram of a 3 stage active bandpass filter is: fc1=12πR1C1,fc2=12πR2C2,…

Q: 1) the series RLC Grivit shown below is excited. at to by the sinusoida Souru losin 2t, and the…

A: In this question we need to find the following Find current i(t) for t > 0 Indicate the nature…

Q: Bode plots for 4 different dynamic systems are reflected on the same graph. Please try to find out…

A: The transfer function from the bode plot can be derived by calculating the cut-off frequency of the…

Q: A resistor of resistance R=1000 2 is maintained at 17 °C and it shunted by 100 µH inductor.…

A: Given : R=1000 ΩT=17+273=290 K∆F= 15.9×103 Hz

Q: Write down the formula for the frequency response H2(el®). Given: h2[n] = 3=In|

Q: Considor the mossage signal m(t)= 4sin(8000rt). Tho carrior used has a froquency fe= 500 kHz and an…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Copy of For the circuit shown, find the low cutoff frequency in Hz associated with C1 if R1- 9k,…

A: The voltage across R2 is determined using the voltage divider rule as given below:…

Q: M1 Rs R1 Zout R2 (a) (b) · Compute the impedance looking into the source terminal of M1 as a…

Q: In order to change the behavior of a 2nd order underdamped system, we need to move its closed-loop…

A: Transfer Function of Second order system is given as: T/F=ωn2s2+2ξωns+ωn2 Characteristics equation…

Q: Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that 1(t)…

A: We need to find out circuit elements for given current and voltage

Q: Using your integnal represen to tims for J, show that the following are Fourier pairs e just ejwz

Q: 2. Find I and ZT -j20 N jso N | 200/30° V 40 N 20 Ω.

A: Circuit diagram is given as, Equivalent impedance is given by,…

Q: Determine if each statement is True or False; if false, please explain why a) A forced oscillator is…

A: Need to find true false for the given system4

Q: Q₁) find from fig-1 below in state space in phase-variable form, Draw the signal flow gra $²+2 +6…

Q: 0S A discrete system has a frequency response H( - (1+ ces (w)]ee Find the system steady-state…

Q: 3. At what radial frequency will this circuit have an impedance at terminals a and b that is…

A: Given circuit is,Asked to find the radial frequency for entire circuit impedance will be real?

Q: 1. Consider the circuit shown below. Select values for the capacitances and inductances to obtain a…

Q: v(t) is a square signal and the amplitude value of v(t) is 45. What is the Vrms of v(t) in terms of…

A: Any signal which is continuously varying with time has a RMS value. RMS stands for root mean square…

Q: Write a difference equation that characterizes a system whose frequency response is H(el) =…

Q: Consider the block diagram below. R + + I E 1 s+1 1 S+4 1 s+2 If R is a step function with amplitude…

A: Given block diagram is The input is a step signal of amplitude 4. We need to determine The steady…

Q: with the fllowing bade diagram, get the trarsfer function H(W) qnd meke the phase digram Show every…

Q: By properly choosing the value of K, the output c(t) of the system shown in Figure can be made to…

Q: The onalog Butlerworth Family, which has the following Characteristics design2 Find the transfer…

A: Given Data:Passband attenuation Stopband attenuation Passband frequency Stopband frequency To…

Q: 2- The RT value at A and E point at the circuit are : * 10 C I4 Iz 25 $15 20 V. 5 E В ww

Q: 5. Consider the system having transfer given by: K G(s) s(s + 4)(s+ 4 + j4) Determine the angle of…

A: Angle of departure =plus or minus 180(2q plus 1)+phi Where pi is net angle contribition by the all…

Q: In order to change the behavior of a 2nd order underdamped system, we need to move its closed-loop…

Q: Find the frequency response of the system below G(s) = 9s +15 2s² +98 +9

Q: U₁ 2 L₁ C www.l wwww L₂ U₁₂ R The circuit comprises two inductors with L, = 15 mH. For a frequency…

A: At and at

Q: phose at Jain cooss outh

A: GAIN MARGIN: The additional gain that can be introduced in a system without affecting its stability…

Q: Sketch the output wave of the circuit below, with the input wave is given! 120 V C Ideal R Vị E 20 V…

Q: Given: A = 2a, -2.7a, + a, and B = a, +2a,-3a,. Find the z-component of (2A + B) x (A-2B). %3D O a.…

A: Component: The component of the vectors shows the direction of the vector in the space.

Q: Find the Thevenin equivalent voltage and impedance between points a-b. Then Show the magnitude of…

A: In this question we need to find the Thevenin equivalent voltage and impedance of the given circuit…

Q: a)Compute the 3658-3458 in 2’s complement signed magnitude form.

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: find the IFFT DIT for the following

Q: Please solve for d,e,f. Thanks

A: Part d: Consider the given expression, Now, consider the denominator of the transfer function,

Question

Find H(@) of a 3-point weighted adder, given by the input-output relation:
k² +1
y(n) = E
x(n-k). Also find the amplitude |H(@)| and the phase Z H(@).
k + 2
k=0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Pls show neat and whole solution.
If the signal power in dB is 16.042 dB, then the signal 3dB power is equivalent to. Group of answer choices 8.021 watt 20.1 watt 13.042 watt 40.2 watt
• For the system shown below, find a state-space representation in phase-variable form. 20 S5 + 5s4 +7s3 + 3s² + s + 20
Please solve quickly
what is the z component of A + B
Given E (s) = Z (s) I (s). Find impedance Z (s). R RC's+1 RCS R-Cs OR+Cs OR+ s R M C Z e
With the given circuit, write the impedance equation.
Consider the complex numbers Z3 and Z4 defined below. Z 2490 Z = 42- 90° Compute Z4/Z3 and specify its magnitude in the box below.
4. Find sinc (10w) * sinc (7w). HINT: do not try to do the convolution directly. E >
Given the circuit below and the associated set of voltages and currents, the real Power delivered by the independent voltage source is V3 10 j2 N + j3 N 12ΩΕ V1. 39 I, -j16 N V, = 150 /0° V Vi (78 - j104) V V2 (72 + j104) V I, = (-26 – j52) A I, = (-2 + j6) A I = (-24 - j58) A V3 = (150- j130) V Copyrighe 201st Peirse Ecation inc putlishing as Piene Hal Note: The given values are not RMS values.
The impedance of a series combination of a 10 resistor, a 10 capacitor, and a 10 inductor is a. 14.14 450 b. 14.14 -450 c. 10 90o d. 10 0o
The circuit below is switched at t = 0 after reaching the steady-state. From the given circuit below, find the following. 1. Neper frequency(in rad/s) 2. Resonant Radian Frequency(in rad/s) 3. Root of characteristic equations that is closer to the origin 4. What is the value of A1 from the form of natural response v(t) = A1e-854t + A2e-146t such that the experiment is repeated with v(0) = 25V and dv(0)/dt = 0 V/s.