Figure shows a typical microwave receiver used in satellite commuối colionfigure of the receiver i the overallCalculate i) theoverall noiseequivalentof the receives Assume the ambient temposaturetempe ratureT=17°C-Te -SK F2= Sd Bo64 F3= 12dBor 16Mixer andSF a mplifiesAntennaTo detectorMasterAmpTWT%3DG, = 3odB 2= 20dB Gg=40DBOFDr 100008 LO0101000

The unwanted part of signal is called noise. Noise is equal to standard deviation of signal. Noise…

Figure shows a typical microwave receiver used in Calculate li) the overall hoise figure of the raceiver (i the overall equivalent temperature of the receiver Assume the ambient temposatura T=17°C- Te-SK F2= Sd Bo64 F3=12dBor 16 Mixer and SF ampli fies Antenna To detector Mastes Amp TWT G = BodB 2= 2odB Ga-40d Bor %3D or LO0 L01000

Figure shows a typical microwave receiver used in Calculate li) the overall hoise figure of the raceiver (i the overall equivalent temperature of the receiver Assume the ambient temposatura T=17°C- Te-SK F2= Sd Bo64 F3=12dBor 16 Mixer and SF ampli fies Antenna To detector Mastes Amp TWT G = BodB 2= 2odB Ga-40d Bor %3D or LO0 L01000

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain the principle behind SP log and gamma ray log?
# The figure above represents the spectrum of a pulse train, Fo= 2KHz 1- What is the frequency of the fourth harmonic? 2-What is the power of the Second harmonic? 3- When does the first null occur? 4- Calculate the duty cycle of this signal. 5- What does the space between the pulses equal 1? Reference level = 20 dBm Centre Frequency = 40KHz Span 80KHz/ division
What is the frequency of operation for commercial microwave ovens?
Estimate the VSWR if the reflection coefficient is 0.5
FM slope detector is a kind of demodulator circuit, how it is demodulated in the receiver?
modulatid sls gien ly Q2 An angle = 10 Cos (13o00t) W. = 12, w0 ニ ) Cal mlt) astuning it a ,kp3l vo PM tware an FM wave, Kp= Ivo. 11) Cal. mih eshuning
mosfet low frequency question
If the reflection coefficient is 0.75, estimate the return loss for the device
2. State the factors affecting radio wave reflection, diffraction and refraction. 3. Differentiate Critical Frequency and Maximum Usable Frequency.
Which of the following statement is incorrect? A. Assuming that XTAL = 10 MHz, TCNTO = 50 to generate a delay of 15 us in Normal mode. %3D Assuming that XTAL = 16 MHz, Prescalar N = 8 and OCRO= 7 to generate a square wave pulse with duty cycle 50% and frequency 1MHZ. C. Assuming that XTAL = 10 MHz, OCRO = 149 to generate a delay of 15 us in CTC mode. D. Assuming that XTAL = 8 MHz, Prescalar N = 256 and TCNTO= 131 to generate a delay of 4 ms in Normal mode. %3D
13 The study of energy distribution across the frequency spectrum of a given electrical signal is done by a a-Distortion meter. spectrum analyzer. b-wave analyzer. d- Q-meter. nogurately measured by