Figure 2 shows a built-up cross-section of a horizontal beam which has a maximum shear force of 100 KN. Calculate the shear stresses and plot the shear stress distribution (Approximate the shear stress at the Neutral axis).

Q: A hollow steel box beam has the rectangularcross section shown in the figure. Determinethe maximum…

A: Given Allowable shear stress = 36 MPa To find Allowable shear force

Q: show all steps/solution

A:

Q: 10 kN 3 kN/m 100 mm 200 mm B 1.5 m 1.5 m 2.2 m

A:

Q: For the simply supported beam subjected to the loading shown, derive equations for the shear force V…

A:

Q: Ql: For the simply supported beam shown below, calculate the maximum stresses in the steel and wood…

A: To calculate the N.A. of the section:

Q: .) Calculate the cantilever support reactions at A b.) Calculate and draw the stress distribution…

A: The given beam is as shown below, Calculate the reaction at the support A, The angle θ…

Q: Consider the beam shown in the figure . Suppose that w1 = 560 N/m , w2 = 280 N/m . Follow the sign…

A: The detiled solution is given below.

Q: The beam shown in the figure is supported at roller A and pinned at B and has a uniformly…

A:

Q: 0.00 19.00 kN-m Moment diagram I₂ = 22×106 mm* Beam section y 10.00 -26.00 kN-m 100.00 mm 200.00 mm…

A:

Q: The beam shown in the figure is made of Wood that has an Allowable Shear Stress of 200 psi;…

A:

Q: Problem 6-53: The beam is made from three boards nailed together as shown. If the moment acting on…

A: The cross-section area and the centroid values are as follows-

Q: 7.0 kN/m 4m 16 m

A: given; ⇒reaction force at A=RA⇒reaction force at B=RB⇒load intensity (w)=7KN/m⇒AC=16m⇒BC=4m

Q: Problem 6-57: Determine the moment M that should be applied to the beam in order to create a…

A:

Q: 2. For the 20 meter beam shown, there is a roller at "A" (Ay = 52 kN; it is acting upward), and a…

A: For the 20 meter beam shown, there is a roller at "A" (Ay= 52 KN; it is acting upward), and a pin…

Q: For the beam shown, the magnitude of the distributed load is wo = 11.8 kN/m and the beam length is L…

A:

Q: A simply supported I beam is 12 metres long with a midspan point load of 15 kN and a uniformly…

A:

Q: The simply supported beam is subjected to the loading and has cross-sectional area as in the figure…

A: Draw a free-body diagram of a given beam.     Apply force equilibrium in a vertical direction.…

Q: Consider the beam shown in sketch below, hinge supported at point A and roller supported at point D.…

A: Considering the cross-section of the beam The web is denoted as 1 and flange is denoted as 2