Answered: Figure (13.16) shows a liquid of… | bartleby

Related questions

Question

Figure (13.16) shows a liquid of density 1200 kg/m
flowing steadily in a tube of varying cross-section. The
cross-section at a point A is 1-0 cm and that at B is
20 mm', the points A and B are in the same horizontal
plane. The speed of the liquid at A is 10 cm/s. Calculate
the difference in pressures at A and B.
A.
B
Figure 13.16

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

> Question 4 of 8 > © Macmillan Learning A 0.573 kg metal cylinder is placed inside the top of a plastic tube, the lower end of which is sealed off by an adjustable plunger. The cylinder comes to rest some distance above the plunger. The plastic tube has an inner radius of 5.37 mm and is frictionless. Neither the plunger nor the metal cylinder allow any air to flow around them. If the plunger is suddenly pushed upwards, increasing the pressure between the plunger and the metal cylinder by a factor of 2.31, what is the initial acceleration a of the metal cylinder? Assume the pressure outside of the tube is 1.00 atm and that the top of the tube is open to the air. a = 27.29 Incorrect m/s² 100 > Attempt 3
Chapter 12 Fluid Mechanics A level (horizontal) pipe contains a non-viscous, incompressible fluid with a density 1200 kg/m3 that is flowing steadily. At one position within the pipe, the pressure is 300 x 103 N/m2 and the speed of the flow is 20.0 m/s. At another position, the pressure is 200 x 103 N/m2. What is the speed of the flow at this second position?
3 / 6 | 100% + | @ 2. A glass tube is bent into the shape shown, and filled with water. The right end of the tube is open to the air, but the left end of the tube is sealed. What is the pressure P₁ of the gas inside the sealed left end? (Note: the answer is not Patm.) BJ 0.5m 0.4m 0.3m 0.2m 0.1m Om PL ..... S ...
A 25 m tall pipe, closed at the bottom, but open at the top to the atmosphere (which is at a pressure of 1.013 × 105 Pa), is filled to the brim with oil, resulting in the pressure at the bottom of the pipe being 2.0 × 105 Pa. The oil is then poured out and the pipe is then filled to the brim with pure water. ii) What is the pressure at the bottom when the pipe is filled to the brim with the water? a) 2.0 × 105 Pa b) 2.5 × 105 Pa c) 3.0 × 105 Pa d) 3.5 × 105 Pa e) 4.0 × 105 Pa