Fig. 3 shows the load torque variation for one cycle of a shaft driven by a constant torque With an appropriate value of speed, determine the cross-section of the rim when the rim twice the thickness and the total speed fluctuation not to exceed 0.2. Assume density of r as 8050 kg/m³ and Imachine is 125 kgm?. Torque (Nm) 1000 800 O (rad) 47 -350

Q: What is use to clean solutions that eventually become spent and must be disposed of properly

A: Few washers are used to clean solutions. These are given as, (1) Sump pits (2) Car washers (3) Part…

Q: Problem 1: The The uniform 30-kg ventilation door OAP is opened by the mechanism shown. Plot the…

A:

Q: The indicator needle on a speedometer is heldto the zero position by ___.a. magnetic forceb. the…

A: A sort of tachometer is a wheel speed sensor, often known as a vehicle speed sensor (VSS). It's a…

Q: List five different types of oil rating systems

A: Oil Rating Systems:- The society of Automotive Engineers SAE has established a numerical code…

Q: Explain each box. which one is blocked and where is aif flowing

A: Given :-  Two way valve  Three way valve  Four way valve  Four way 5 ported valve

Q: What prevention measures would the student take to prevent fluid overload?

A: given; What prevention measures would the student take to prevent fluid overload?

Q: what can be caused by excessive negative caster

A: Solution:

Q: It is common practice to assign a larger portion of the location tolerance to the hole.

A: Fill in the blanks.

Q: A low Reynolds number will result in a precipitate a. Bad sort b. Good sorting c. round c. Uncertain

A: A low Reynolds number will result in a precipitate  Good sorting.

Q: Technician A says that a micrometer can be used tomeasure the outside diameter of something.…

A: Micrometers exist in a variety of forms, depending on what they're used for. An exterior…

Q: Coolant hoses are being discussed. Technician A states that many manufacturers recommend coolant…

A: Coolant hoses are to be maintain and replace in certain time interval, it fails due to high…

Q: Write down the name of Primary Control Surface

A: The rudder is a fundamental control surface which is typically controlled by pedals rather than…

Q: Describe how to measure main bearing oil clearance

A: Estimating principle oil bearing freedom is one of those means that all great motor developers…

Q: Worn teeth on a speed gear can cause?

A: worn teeth creates a big problem in gear drive.

Q: Why should a technician not file the rough surface on the contractors contacts

A: Solution:

Q: What is the function of safety valve?

A:

Layout

The layout is a way of organizing the elements, products, and raw materials in a design. The layout is the representation of information in a structural, logical, descriptive, coherent form.The layout is a mapping of various equipment arrangements, workstations, machinery, plants, and more. It secures the continuous movement of a product quantity along with the quality.