1. Express the following in Phasor or Instantaneous form :Find Phasor Form:a.A = 5sin(2t +5x) ŷb.B = 3cos (wt- 2z)x- 3cos (wt- 2z)xc. C =50sin (wt-2z)pFind Instantaneous Form:d. D, = - j50e-6ze. E, = e* (i-2)sin (zy)

Answered: Express the following in Phasor or…

Express the following in Phasor or Instantaneous form : Find Phasor Form: a.A = 5sin(2t +5x)ŷ b.B = 3cos (wt - 2z)î-3cos (wt-2z)i c. C = 50 sin (wt-2z)p

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A complex number is represented as Z=4+j3 ohm. What will be magnitude and phase of this complex…

A: For any complex number, C=A+jB, the magnitude and phase of the complex number can be expressed as

Q: a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor…

A: The solution can be achieved as follows.

Q: Find the following phasors. אלל jue J.1 Vt 2.1 Vz 23 13

Q: sketch the waveform of the voltage and current.

Q: Find the effective value of a sinusoidal voltage with a maximum value of 110 V.

A: Maximum value Vm = 110 v Effective value = ? Effective value is also called as RMS value.…

Q: C. Draw a general sine wave V vs t and I vs t plot for a purely resistive and a purely inductive…

Q: R 200 Vs -100V C. - j10 Calculate the magnitude of the voltage drop across the capacitance.

A: In this question, What is magnitude of the voltage drop across the capacitance? We are solving…

Q: For the circuit below a. Find total impedance and admittance of the circuit in polar form. b.…

A: Given circuit is,Asked to find,total impedance and admittance of the circuit in polar form.Total…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees. Here the answers…

A: Step 1: Step 2: Step 3: Step 4:

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an…

A: The given circuit isWe need to find The formula for the total impedance, Ztot.The formula for the…

Q: the sinusoidal current i using phasors.

Q: For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re…

A: The period of the sinusoid is given; the frequency of the sinusoid is calculated as shown below:…

Q: The current through a 20 2 inductive reactance is given. What is the sinusoidal expression for the…

A: For the given specifications of the inductor and the current the equivalent voltage across the…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees. Here the answers…

A: Step 1:

Q: Convert -20 sin (wt + 10°) to cosine. Convert 20 sin (wt + 10°) to cosine.

Q: QS: The current through a 2 kfl capacitive reactance is given. Write the sinusoidal expression for…

Q: 12 cos 3t V R www + L m 4 sin 2t A 10 V If we would like to use Superposition to solve for vo in the…

Q: An electromagnet that is modeled as a resistor R=20 ohms and L=0.3 henrys in series, is connected to…

A: Electromagnet modeled as series connection of resistance and inductance whose values are 20 ohms and…

Q: Find the magnitude of the total current.

Q: -j 202 j 50N +, 200230° 402 202 Figure 9.

Q: Given V 20 sin(@t + 60°) and V2 %3D = 60 cos(@t-10°) What is the phase angle between the waveforms?…

Q: Convert the following phasors into sinusoidal waveforms a. Vị = 20+j15 V, w= 10 rad/s b. Vị =…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Write equations for the waveforms of Figure. Express the phase angle indegrees. Here the answers…

Q: How can you tell which phasor is lagging when the two phasors don’t start in the same location such…

A: It is given that:

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: P.3: Find the rms value for the following sinusoidal waveforms a. v= 120 sin(377t +60°) V b. i6x 10³…

Q: Determine the phase relations between the sinusoidal waveforms v = 10 cos (ωt + 10o) V i = 5 sin (ωt…

A: In this question, We need to Determine the phase relations between the sinusoidal waveforms? v =…

Q: ) Cenvert the following phasors to the time domain if the frequency is I KH. b) h-12 / A

A: Phasors are the simple and easily understandable representation of the time-domain signals. suppose…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in series with a function…

Q: What is the phase relationship between the following waveforms? v = 10 V sin(@t + 60°) i= 2 mA…

A: Phase relationship

Q: Segments of two sinusoids are shown in the plot below. Determine the phase difference between the…

Q: Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then…

A: The half time, The resistance,

Q: Find v₁ and v2 for o= 10000 rad/sec. Sketch the waveforms for vs, v₁ and v₂. Repeat for 0= 100…

A: Given Data:DC and AC equivalent circuits of a main circuit having both,DC voltage andAC voltage To…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: Question2): Find the current and voltage for each element in the circuit shown and sketch the…

A: KCL: According to Kirchhoff's current law, the sum of current entering at a particular node=Sum of…

Q: An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in…

A: When the same current flows through all the elements, they are said to be in series. When the same…

Q: sinc function properties Review Consider the Fourier Transform is G(f) = 1.3sinc(0.02nf). Select an…

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45° A

A: Given, Two magnitudes with angles , We have to draw the phasors. Please find the below attachment…

Q: Find the phasor voltage Vab between points A and B in the figure.

Q: If the phasor current is 45 degrees ahead of the phasor voltage, write down all the possibilities…

A: A good question based on simple current and voltage phasor . Have a look at the solutiom I have…

Q: QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function…

Q: A voltage y(t) = 10 cos(2000xt) is applied to a 100-mH inductance. Find the complex impedance of the…

Q: For the component shown in figure, find the sinusoidal current i using phasors. i L 240 pµH v = 8…

Question

1. Express the following in Phasor or Instantaneous form :
Find Phasor Form:
a.A = 5sin(2t +5x) ŷ
b.B = 3cos (wt- 2z)x- 3cos (wt- 2z)x
c. C =
50
sin (wt-2z)p
Find Instantaneous Form:
d. D, = - j50e
-6z
e. E, = e* (i-2)sin (zy)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

6. Draw phasor diagrams for the following: c) 8Z45° d) 2 –3 Z 5°
3. A sinusoidal voltage is applied to the circuit below. Determine the following: I, Irms, lavg, Ip- 1.0 kN
For the component shown in figure, find the sinusoidal current i using phasors. ? + C = 0.47 µF V = 200 mVZ+90° f = 1 kHz
4) Find current phasor I for the following AC steady state circuit. j35 O -j14 2 12/0° V 103 n3 j25 Q
Find a single sinusoid corresponding to: I= -2j +10/-45° i(t)=I,cos(@t+D) , D=(......)°
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
The voltage across a 50 resistor is 30 sin (377t-20). Find the sinu: expression for the current. O a. 6 sin(377t + 20) Ob. 6 sin(377t - 20) Oc. 30 sin (377t - 4) Od. 6 sin (377t)
Q9. i) An inductance network with total inductance across A and B is 30mH is shown in Figure CI. L4 L2 = 40mH L6 = 40mH Leq-30mH L1= 20mH L5 50MH 100mH 30mH B. Figure C1 Estimate, inductance value, L4. [3]
write the phasor equivalents
a) Using your own words, describe how triangular waveforms are produced from sinusoidal waveforms. b) Write a sinusoidal formula that will produce a triangular wavefor y c) Demonstrate your understanding by plotting the formula shown in b using any of the plotting software.
Prob. I and Vc For the following RMS phasor circuit, a coworker has determined values for 50 Ohms 50 Ohms i,- 225 2253.13° = 190.92 + 254.56 VRMS R1 + R2 Vc = 237.17/26.565° = 212.13+ 106.07 VRMS 100 2 -3Z98.13° =-0.4243 + J2.970 ARMS C -j60 Ohms For this problem provide at least 3 digits of precision for the answers. The results for the following calculations are to be answered in - a) Find the current I b) Determine the real (P) and reactive(Q) power DELIVERED by the source c) Determine the real (P) and reactive (Q) power ABSORBED by each impedance ( resistors R1 and R2, inductor and capacitor). The values for P and Q can be positive or negative. Remember S =P+jQ, so do not include the j with your answer for Q. Each of these answers will require two parts. For the phasor a magnitude and angle will be needed. For the powers, The real power P and the reactive power Q are required.
The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there are no reactive components in the AC circuit the resistance of the circuit is equal to the reactance of the reactive components the inductive reactance and capacitive reactance are equal in magnitude there are no inductors in the circuit