Example In following Figure a node with physical address 10 sends a frame to a node with physical address 87. The two nodes are connected by a link. At the data link level this frame contains physical addresses in the header. These are the only addresses needed. The rest of the header contains other information needed at this level. The trailer usually contains extra bits needed for error detection 10 Trailer 28 T2 Data 53 65 87 10 87 Source Destination address address

Example In following Figure a node with physical address 10 sends a frame to a node with physical address 87. The two nodes are connected by a link. At the data link level this frame contains physical addresses in the header. These are the only addresses needed. The rest of the header contains other information needed at this level. The trailer usually contains extra bits needed for error detection 10 Trailer 28 T2 Data 53 65 87 10 87 Source Destination address address

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. For 8-bit binary numbers: a. Compute 125-75 using 2's complement to represent negative numbers. Indicate if there is overflow. b. Compute -55-73 using 2's complement to represent negative numbers. Indicate if there is overflow.
In a communication, the transmitted data is 0 1100010 1101 and the received data is 0 110111 1010 1. For error detection, 2D Parity algorithm is used with (3 row and 4 column). Which answer is correct? O a. Error is detected by row and column, but cannot be corrected b. Error cannot be detected O c. Error is only detected by row, but cannot be corrected O d. Error can be detected and corrected O e. Error is only detected by column, but cannot be corrected
14.3.6 - What field is sent in period 8 of an I12C message? ACK The read/write bit The STOP condition NACK
2. Convert the following decimal numbers to 6-bit two's complement binary numbers and subtract them. Indicate whether or not the difference overflows a 6-bit result. (a) 1810 - 1210 (b) 3010 - 910 (c) -2810 - 310 (d) -1610 -2110
Two features of the HDB3 code are Select one or more than one: a. Allows the synchronization of the reception of digital information b. Does not remove D.C. level. c. Eliminate the problem of long sequences of Zeros d. facilitates impedance matching
I need the answer as soon as possible
Question-1: 1. Using a 4-bit full adder block/s only, perform A x B, where A is a 7 bits binary number and B id a 3 bits binary number. A = a6 as a4 as az ai ao B= bz bị bo You may use any basic gates (and/or/not) and any amount of 4-bit adder block circuit only.
QUESTION 2 In order to select the chip A19-A15 must be set to B.(Give only the five binary bits.) A14 A19 32K×4 A15 CS
A- 1. AND 2. OR A B• 5. XOR A A- 3. NAND 4. NOR O 6. XNORO B 7. 8. A. Butter Inverting Butter Provide the output for the following operators:
In a communication, the transmitted data is 0 11000 101101 and the received data is 0 1101111010 1. For error detection, 2D Parity algorithm is used with (3 row and 4 column). Which answer is correct? O a. Error is detected by row and column, but cannot be corrected O b. Error cannot be detected O c. Error is only detected by row, but cannot be corrected O d. Error can be detected and corrected O e. Error is only detected by column, but cannot be corrected
i need the answer quickly
What output does the following multiplexer output? Note: if a line is cut and a number is written, it shows how many bits or how many lines are there. The lines below are 4 bits.