Question 3: complement A) Determine which of the following odd parity codes are in error: (1) 11110110 (3) 01010101010101010 B) Convert cach binary number to (2) 00110001

Q: What is the mean value of half-wave rectified output signal if the peak voltage of input sine wave…

A: Peak voltage Output waveform of half wave rectifier is given by,

Q: With the aid of illustrations explain the difference between an analogue and digital signal and…

A: Analog Signal:An analog signal is a continuous signal that varies over time. It can take any value…

Q: In Analog to Digital Converter (ADC) the input will be in digital form. O a. TRUE O b. FALSE

A: Analog to digital converter (ADC) are the converters that convert analog signal to digital signal.

Q: Write an assembly code in 8051 microcontroller where the input is the temperature sensor, goes…

A: We have to write an assembly code in 8051 microcontroller where the input is the temperature sensor,…

Q: Digital Electronics Q1): Draw the timing diagram showing the Q output of each F.F (Q0, Q1): HIGH FFO…

A:

Q: als are at the same A depletion mode JFET is a. normally on and must be biased off. b. normally off…

A:

Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and THD…

A: D . FF and TUF equal to unity .

Q: a) impulse current generator , generation of switching surges , generation of high frequency high…

A: We have tobriefly explain impulse current generator, generation of switching surges, generation of…

Q: The following waveforms are measured on the input and output of a rectifier while driving a…

A:

Q: Q) A CRO can be used to measure--- O A.C voltage. O D.C voltage. O Frequency. O All of above.

A: CRO displays the waveform on its screen.

Q: Use a rectifier with an intermediate taker to adjust current if the sine source voltage is 200…

A:

Q: In the single phase full bridge rectifier shown below: a) Sketch the output voltages at nodes A and…

A: NOTE: During the positive half cycle of the input voltage, the diode D1 and D2 will forward biased,…

Q: A single phase half wave uncontrolled rectifier with R load is supplied by an AC source of 230…

A: Last option is correct. The explanation is provided below.

Q: Give 5 examples of wave transducer with descriptions

A: We need to tell about wave transducer .

Q: Find the bias voltages and currents of the transistor circuit below.

A:

Q: Q3 An AC bridge is shown in Figure Q3. It has an AC excitation input and four arms of impedances,…

A:

Q: What is the frequency and what is the period, write the formula

A: Frequency is nothing but repetition of signal per second

Q: Question 2: In the single phase full bridge rectifier shown below: a) Sketch the output voltages at…

A:

Q: O 0.3 O 0.5 O 0.7 O 0.9 O 1.1 O 1.3 O 1.5 O 1.7

A: Answer: t = 0.5 seconds

Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and TUF…

A:

Q: What happens to cut-in voltage when the temperature increases? a) Cut-in voltage increases b) Cut-in…

A: Option :b ( correct answer)

Q: Adavantages and disadvantages of ANALOG IC

A: ADVANTAGES  ANALOG ICS use less energy; There by involving lesser heat consumption and hence…

Q: The efficiency of bridge rectifier is approximately a. 50.5% b. 40.6% c. 81.2% d. 20.6%

A: Rectifier efficiency  It is the ratio of DC POWER output to the AC POWER output. Efficiency = DC…

Q: 17. If a frequency modulator produces 4 kHz frequency deviation for a 10-Vp modulating signal,…

A:

Q: Advantages and disadvantages of DIGIT IC

A: Brief description : Digital integrated circuits are one of the major advantage on the analog…

Q: p-channel JFET used in Digital technology as_____. a.switch b.rectifier c.invertor d.amplifier

A: JFET is a fully controlled device with help of applied gate voltage between the gate and source .…

Q: Electromagnetic waves can act as carriers for ) Amplitude ) Vacuum tubes ) Radio waves A device that…

A: Carrier waves are electromagnetic waves that movement with the speed of light and don't need a…

Q: This type of circuit might be used in A B En Address buffers Data buffers The timing circuit O The…

A: Ans :- Data buffers  This type of circuit is used in data data buffer.

Q: A pn junction acts as a a. Controlled switch b. Bidirectional switch C. Mechanical switch d. None of…

A: The solution is given below

Q: With suitable sketch ,explain in detail the calibration procedure of differential pressure…

A: Differential Pressure Transmitter- Differential pressure transmitter is a device which is used…

Q: Deter min the system Runction and unit samPle responce for equatron yin) = y (n-1) + 2x (n)

A: In this question we need to find a transfer function of the system and responce of the system when…

Q: What are the analogue instruments in aircraft

A: Generally to indicate the location and the weather and the direction and the degree of aeroplane…

Q: Purpose of electrical instrumentation

A: To find the purpose of electrical instrumentation

Q: OLU The state diagram for a negative edge triggered counter is chown below. Sketch the corresponding…

A: Since the counter is counting to the number 15, the required number of the flip-flop will be four to…

Q: or op-amp wien bridge oscillator if the oscillator stops after few cycles then the cause is?

A: An Op-amp Wein Bridge oscillator is shown below: It is one of the simplest sine wave oscillators.…

Q: What is the required input voltage at AREF pin in Arduino UNO to have LSB voltage resolution of 1.47…

A: Given, Resolution of Arduino Uno is 1.47 mV. The Arduino Uno ADC is of 10 bit resolutions.

Q: . The phase shill oscillator depends on Teedback....................

A: The phase shill oscillator depends on POSITIVE Feedback.

Q: For L load uncontrolled rectifier, draw the grah of the output current and output voltage.

A: For L- load uncontrolled Rectifier  To draw the graph of output current and output voltage

Q: What is digital demodulator

A:

Q: TOPIC: Thyristors and Phase Control Silicon-Controlled Rectifiers may be represented by the…

A: The given circuit is shown below. For the given circuit we need to explain the operation with and…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.