Example 5.2. The flexible, inextensible, and gentile cable is suspended between Ewo absolutely rigid supports of same elevation. The total length of the cable is L and span equals I. The cable is subjected to uniformly distributed dead load q within the horizontal line; corresponding thrust and sag are Hq and fg. Calculate a change of the thrust and sag of the cable, if the entire cable upon the load q is loaded by additional concentrated live load P at the axis of symmetry of the cable (Fig. 5.7).

Example 5.2. The flexible, inextensible, and gentile cable is suspended between Ewo absolutely rigid supports of same elevation. The total length of the cable is L and span equals I. The cable is subjected to uniformly distributed dead load q within the horizontal line; corresponding thrust and sag are Hq and fg. Calculate a change of the thrust and sag of the cable, if the entire cable upon the load q is loaded by additional concentrated live load P at the axis of symmetry of the cable (Fig. 5.7).

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A uniform circular rod with a weight of 13 Ib and radius 10 in. is attached to a pin at Cand to the cable AB. A В C Determine the tension in the cable. (You must provide an answer before moving to the next part.) The tension in the cable is Ib.
5. Cables A, B and C support a 50 lb load as shown. Determine; a) The magnitude of the tensions in each cable b) Express the tension in each cable in vector form. 0.3 ft B 1ft 1.5 ft 1.5 ft 2 ft 50 lb
Can you please answer these two questions?
Problem 2.41: Determine (a) the required tension in cable AC, knowing that the resultant of the three forces exerted at point C of boom BC must be directed along BC, (b) the corresponding magnitude of the resultant. D 65° 25° 50 lb 75 lb
The uniform 200 kg bar AB is held in the position shown by the cable AC. Compute the tension in the cable
In the force system, determine (a) The component of the force F acting along the cable AC. (b) The angle the force F makes with cable AC. 1.5 m B 1.5 m 1m F- 560 N 3 m 3m
A - determine the tension in cable ac B- determine the tension in cable ab
the parabolic cable shown carries a uniform load of 120 kN/m. the lowest point of the cable is located vertically 3m from the left support and 6m from the right support. if the length of the cable is 100m A.) Determine the lowest point in meters, of the cable measured horizontally from the left support. B. ) determine the value of the minimum tensile force in kN, that the cable can withstand C.) determine the value of the maximum tensile force in kN, that the cable can withstand
The tension of cable AC is 110 N. Determine the mass of the crate at point E. g=9.81 m/s² 3m E -3m 6m B 2m y
Please answer asap
Show FBD and complete solution. The load on the cable AB is uniformly varying. It is attached to a wall at A and is supported at B by a horizontal force of 1250 N. Calculate the load intensity (W) at point A.