Example 12.22 100,000 kg engine is moving up a slope of gradient 5 at a peed 100 m/s. The coefficient of friction between the engine and the rails is 0,1. If the engine has an efficiency of 4% for converting that into work, find the amount of coal, the engine has to burn up in one hour (Burning of 1 kg of coal yields 50,000 joules)

Example 12.22 100,000 kg engine is moving up a slope of gradient 5 at a peed 100 m/s. The coefficient of friction between the engine and the rails is 0,1. If the engine has an efficiency of 4% for converting that into work, find the amount of coal, the engine has to burn up in one hour (Burning of 1 kg of coal yields 50,000 joules)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

11. pls answer...
Please answer with explanation Thanks
A power shift crawler dozer is working in tough clay and pushing it 150 feet. The blade capacity is 10 LCY. Maximum reverse speeds are as follows: first range, 3 mph; second range, 5 mph; and third range, 8 mph. The job efficiency is 55 minutes per hour. Find the expected dozer production per hour
A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is 10 m. Compute the energy added by the pump. a.8502 b.130 c.10257 d.7651.8
Find the coefficient of friction is friction force is S50 N and Normal force 100 N
A sluice gate weighing 18 kN is raised and lowered by means of square threaded screws, as shown in Fig.10.30. The frictional resistance induced by water pressure against the gate when it is in its lowest position is 4000 N. The outside diameter of the screw is 60 mm and pitch is 10 mm. The outside and inside diameter of washer is 150 mm and 50 mm respectively. The coefficient of friction between the screw and nut is 0.1 and for the washer and seat is 0.12. Find : 1. The maximum force to be exerted at the ends of the lever for raising and lowering the gate, and 2. Efficiency of the arrangement Subject: Theory of Machines
This question is from a study guide.
1. A moving company rigs a pulley system to lift a piano to a fourth floor balcony 44 feet from the ground. The pulley system has 7 ropes with one pulling down and 6 supporting the load and the piano weighs 1200lbs. What is the Ideal MA of this system? Assuming 88% efficiency what is the True MA of this system? True MA, how much force would be required to lift the plano? the piano to the balcony? Using the How much rope would be pulled to lift
Plz do as fast as possible ....!
pls show solution. using only e = mgh, with g as 9.8, is incorrect
Calculate the value of work done to move a cycle of 3 kg to distance of 3.1 m
4. Show with sketch how to measure the resistance for the airway of patient. 5. What are the main design parameters of the pump have to be calculated?