Ex. (4): The figure shows a 1-kg collar that slides along the frictionless vertical rod under the actions of gravity and an ideal spring. The spring has a stiffness of 160 N/m, and its free length is 0.9 m. The collar is released from rest in position 1. Determine the speed of the collar in position 2

Ex. (4): The figure shows a 1-kg collar that slides along the frictionless vertical rod under the actions of gravity and an ideal spring. The spring has a stiffness of 160 N/m, and its free length is 0.9 m. The collar is released from rest in position 1. Determine the speed of the collar in position 2

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

dynamic
Cart 1 Mass - M Cart 2 Mass = 3.5M Force Sensor The spring cart (cart 1) is released and collided inelastically with cart 2 and the two carts move off together. The spring does not add any mass to cart 1. Assume negligible friction in the cart wheels.
Plz solve within 30min I vill give definitely upvote and vill give positive feedback
In the figure, masses of a sphere of radius r and mass m are compressed between two neglected rods. The length of the bars is indicated by l, and the angle they make with the vertical by the angle. The force applied from the ends of the rods is in the horizontal direction and its magnitude is given by P. Friction between sphere and rods is neglected. Therefore, find the acceleration of the sphere in the vertical direction when the angle is 30º in terms of the given magnitudes. Note: Treat the sphere as the material point.
A steel ball of mass M is held at a distance H above a massless rigid tabletop supported by undamped springs whose equivalent stiffness is K. If the ball is left to fall from rest on the tabletop. Deduce an expression for the velocity at which the ball will bounce back off the tabletop. On its way back, will the mass bounce back to its initial height? If it will not, where will the difference in energy go? Discuss mathematically! (Pls solve the question in detail with figure)
In the system in which the first starts to move without speed, the masses of 10, 1 kg each, with the effect of the 18 N force T, with a radius of R=578 mm in t secondsIt reaches an angular velocity of 141 rpm. Since the radius of the pulley is r= 165 mm, ignore the friction and all the masses except the four masses.Find t by
I need the answer as soon as possible
Please do it ASAP its urgent
A 4kg collar as shown in the figure below is released from rest at position A and slides down the inclined rod at 60° from horizontal. The friction coefficient is 0.2. Calculate a. The velocity of the collar immediately before it touch the spring b. The maximum deflection of the spring 4 kg 0.5 m H = 0.2 60° k = 2 kN/m
5) A block weighing 50 lb is shown on an inclined surface. The block is released from rest at the po- sition shown. The spring has a spring constant of k = 10 lb/in., and the coefficient of friction be- tween the block and the incline is 0.3. What is the maximum compression of the spring? 6) For the system in Question 5, what is the velocity of the block the moment it leaves the spring? 50 lb 10' 30° K www. Page 1 of 2
please answer with complete solution!
The 150-g hockey puck initially rests on a surface at A with the spring compressed by 0.2 m, as shown. The kinetic friction coefficient between the surface and the puck is ?? = 0.1. The puck is in contact with the spring but is not attached to it. Subsequently, the spring is released. Determine the minimum stiffness of the spring so that the puck just clears the wall at B. Use any method(s) that you like