Eripplepk-pk = 0.75V Standard average current diode rating : 1A, 2A, 3A, 4A, 5A Standard peak current diode rating: 5A,10A, 15A Transformer: 200mA, 250mA, 500MA, 750mA, 1A, 2A, 5A

Q: What will be the modified form of the codeword is even parity is used: 011010

A: When parity is used, then the parity bit is added to the left-most position of the bitstream.  In…

Q: I, I. The values of E, R, and I are given on the Student Values Spreadsheet. Give the values of I1…

A: Given circuit, Where, E = 62 VR = 31 OhmI = 87 A

Q: Which one is the correct statement? Select one: O a. All of the other statements are incorrect. O b.…

A: The HMI is linked to the SCADA supervisory computer to provide live data to drive the mimic…

Q: "Implement the yellow highlighted table using multiplexers considering the digits used above (88 72…

A: According to the question, for the given table as shown belowWe need to implement the yellow…

Q: SUBJECT: COMMUNICATIONS 1: PRINCIPLES OF COMMUNICATION SYSTEMS FOR ENGINEERS TOPIC: Introduction to…

A: 1) What  are the challenges in electronics communication at present 2) what has been the role of EE…

Q: how did you find Rth?

A:

Q: Complete the number conversions indicated. Note that all binary numbers are two’s complement…

A: A binary number is a number which is expressed in base-2 system by using only "0" or "1" digits.…

Q: Determine the number of page table entries (PTES) that are needed for the following combinations of…

A:

Q: design of a communication system

A: The answer to the above problem is given below:-

Q: 10. An analog system is one in which processed data is in analog form only.

A: we need to find in analog system  processed data is in analog form only.this statement is true or…

Q: Can I get a version of this that can be read?  Maybe a space between equations could help.  Better…

A: It is given that:

Q: For this question, I just need to understand if the analogy is a Multiplexer, Demultiplexer,…

A:

Q: H.W: Design (4X4) bidirectional crossbar network. Estimate the total number of AND and OR gates…

A: Parallel processing- The term Parallel processing refer to a method in which two or more processor…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.