[English] Two solid cylindrical rods AB and BC are welded together at B and Knowing that dį = 60 mm and d2 = 40 mm, find the normal loaded as shown. stress in the midsection of (a) rod AB, (b) rod BC. 250 kN 60 kN

Q: Ex : Two solid cylindrical rods AB and BC are welded together at B and loaded as shown , Knowing…

A:

Q: Question 1 B 900 mm 80 mm -40 mm T A The magnesium tube is bonded to the steel rod. Part A If the…

A: Shear stress of magnesium = 45 MPaShear stress of steel = 75 MPaModulus of rigidity magnesium = 18 ×…

Q: A short column is made by nailing two 1 * 4-in. planks to a 2 * 4-in. timber. Determine the largest…

A: Given Data: The top surface area of center plank (A) is of (2 inchx4 inch) The top surface area of…

Q: (5) When the bar subjected to torque, the maximum shear stress occur at.. O A. External surface of…

A: When a bar is subjected to the torque, the shear stress will be produced in the bar.

Q: (a) A steel cylinder of 60 mm inner radius and 80 mm outer radius is subjected to an internal…

A: Note: As per the bartleby guidelines only three subpart will be solved at a time for remaining…

Q: Two cylindrical cross-section rods AB and BC, which are fixed to the wall and welded together at…

A:

Q: Q2) The aluminum rod BC (G-26 GPa) is bonded to the brass rod AB (G-39 GPa). Knowing that Birass…

A: For solution refer below images.

Q: 4. A load P is applied concentrically to the bar shown. If the allowable normal stress is 76 ksi,…

A:

Q: 1.3 Two solid cylindrical rods AB and BC are welded together at B and = loaded as shown. Knowing…

A: Given P = 10 kips To find Average normal stress

Q: b. A draw bar between a tractor and a trailer is made from a length of steel with a rectangular…

A: Given Data

Q: 2. (20%) A rod of diameter, 22 mm is fixed into a wall as shown and subjected to a uniform axial…

A: The forces are The distributed load isThe length are The diameter is

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ =…

A:

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.