EM 3.74 3.75 The gate shown is rectangular and has dimensions 6 m by 4 m. What is the reaction at point A? Neglect the weight of the gate. Hinge 3 m Atmospheric pressure Stop 30 6 m Water PROBLEM 3.75

Q: 3. The face of the gate of a dam is in the shape of an isosceles triangle 6 ft. wide at the top and…

A: Weight density of water (yw) = 62 lb/ft3 Determine the total force due to liquid pressure on the…

Q: Problem #3: 900 N/m 600 N/m |c В (m) C (m) | 12. Determine the resultant force (N) of the…

A:

Q: Determine the support reactions at A and B: 1- Assume A is a pin and B is a roller?? 2- Assume A is…

A: From the given question it is required to calculate the unknown support reactions by considering…

Q: Determine maximum principal stress

A: Given data : The value of normal stress in Y direction (σY)=75 MPa The value of normal stress in X…

Q: 2. Determine the magnitude of the resultant of the two forces shown. F13 kN 30 5=7 kN

A:

Q: The

A:

Q: 23 60* O Rosette. If E₁ = 25μ E2 = 40μ Е3= зом 60° E2 EI what would be a Shear strain in teat the…

A:

Q: 6. The steel gate 2.61m square of thickness 36.1mm is to be lifted by a frictionless pulley. The…

A: Gate of Dam : Gate is a hydraulic structure of dam which surpasses the water through dam. The gate…

Q: find the hydrostatic force acting on the 1 m wide cover ABC R=1.1 H=4.2 h2=2.5

A: Width = 1m R = 1.1 m h2 = 2.5 m H = 4.2 m Find the hydrostatic force acting on the 1 m wide cover…

Q: What is the location of zero shear from A in meters? Given: w = 43, a 3, b = 4, and c 2. w kN/m a m…

A:

Q: W = 1100kg/m^3 Weight of beam AC = 0.08 kN/m Find the following: 1. Internal loads at point A in kN.…

A:

Q: Determine the magnitude of the total force on one face of the area, in kN. * 2) Determine the…

A: From a given figure, it is required to Determine the magnitude of the total force on one face of…

Q: 5. The crate weighing 500N is supported by three ropes concurrent a Find the forces in ropes AB and…

A: Given data in question  Weight of block  Angle To find out  Forces in ropes. Note We have to put…

Q: A vat holding paint( sg=0.80) is 8 m long and 4 m deep and has a trapezoidal vertical ends, 3m wide…

A: The centroid of the trapezoid formula helps to calculate the centroid position of the trapezoid. A…

Q: DETERMINE THE VALUE OF "P" SUCH THAT RAY IS TWICE AS MUCH THE VALUE OF RBY. DEFINE THE VALUES OF…

A:

Q: (7 Problem 1. The concrete (y = 150 lb/ft³) dam shown below retains water (y = 62.4 lb/ft³) at a…

A: Given:Concrete density, γc​=150lb/ft3Water density,γ=62.4lb/ft3Dam height = 25 ftWater depth = 20…

Q: Q2: Non rotating beam shown in the (fig.2), (F=100 lb), find the maximum stress and its location.…

A:

Q: FIGURE 02 6 KN 5-25. 2.50 KN B. 2m 2M FIGURE O3

A:

Q: a. Draw free body diagram b. Determine support reactions c. Determine stress in the cables d.…

A: In the problem, first the FBD diagram has to be drawn following which the support reactions will be…

Q: Q3 50 kN 5 m 5 m. 3々 Analyze the above symmetrical otructure under the given symmetrical loading by…

A: Given: Vertical load=50kn at A  Vertical load=50kn at C  UDL=10×10UDL=100KN By using the diagram…

Q: Construct the shear-force diagram and identify the largest negative shear force. Assume a = 3.7 ft,…

A:

Q: Define what are the different modes of failure of a retaining wall ?

A: Retaining Walls- This is defined as the type of structures that are constructed to retain the…

Q: X w 12M₂ VB 2.3 What is the value of the shear force at x = 2.5 m? w = 3 kN/m L = 4 m

A: Shear force is the algebraic sum of all the forces acting on either left or right side of the…

Q: Find roller support reaction

A: ASKED: To determine the reaction at the roller support.

Q: 2.5 a. Draw free body diagram b. Determine support reactions c. Determine stress in the cables d.…

A:

Q: Wu L1 L2

A: The moment distribution method is a structural analysis method for statically indeterminate beams…

Q: 2.2 A hydraulic press has a ram of 20 cm diameter and a plunger of 3 cm diameter. It is used for…

A: Given: Ram diameter, D = 20 cm Plunger diameter, d = 3 cm Weight, W = 30 kN

Q: EX/ Find h to cause Zero normal stress at Point (b) at base of dam. Find a ? B=1m 3m Assume Xw = 10…

A: Given data: Unit weight of concrete, γconc=24 kNm3 Unit weight of water, γwater=10 kNm3

Q: 3. Determine the magnitude and location of the total hydrostatic force acting on the 2 x 4 m gate…

A: Given, Area of gate = 2m x 4m

Q: B 0.75 m The vertical force at A is: A) 21.58 N B) 67.42 N C) 78.14 N 55⁰ (D) 192.19 N A 1m 0.5 m 50…

A: Given A beam Required  Vertical force at A

Q: 4. Determine the maximum value allowed for the applied force P. Given E = 200 GPa, I = 2x107 mm¹,…

A: Given : E = 200 GPa I = 2 X 107 mm4 Cross section area = 4900 mm2 Allowable Compression stress = 165…

Q: 4. The wide of the dam is x m. a.Find the hydrostatic force on surface AB and its moment about C.…

A: Question is based on the gravity dam . Width, Height and specific gravity of dam are given in the…

Q: F E B 3,2 KN 2.0r G 2. 0 m 8 KN H A 1.5m 1.5 m 1.5m 1.5 m

A:

Q: WHY THE PRESSURE OVER SPECIFIC WEIGHT IS BEING CANCELLED? HERE IS THE PICTURE

A: The given equation represents the Bernoulli's equation and represents the total energy possessed by…

Q: Determine the active force per unit length of the wall y = 16 kN/m 6' = 30° c' 0 3 m Groundwater…

A: To find active force per unit length of wall